User manual ALPATEC AC 9 FITP

[. . . ] cAUTION When using electrical appliances, some rules have to be respected. Take care to install this product by complying with the national rules of electric installation. Make sure that the voltage on the rating plate is same as your main one before plugging. [. . . ] Remote control may be used till 5 to 8 meters, depending on the angle. - If you don't use the remote control for a long time, please take out batteries. - At the end of your product's life, remove the batteries before you hand it for recycling. Your product can be ran either with the control panel or with the remote control In the following, only the control panel will be taken into account. For the remote control please use the following correspondence: On the LCD screen of remote control, indicators of each parameter will light on when needed. STARTING: Plug in the unit, a sound is heard Press button M/A (P), the unit starts setting the last used parameters (mode, temperature and fan speed). Each time, function changes according to following diagram: AUTOMATIC -> HEAT -> FAN ONLY -> COOLING -> DRY A few seconds after, room temperature will be displayed again. ADJUSTMENT OF THE FAN SPEED : Each pressure, fan speed changes according to following diagram: LOW -> MEDIUM -> HIGH During the dry operation, the fan speed cannot be adjusted. When the sensor temperature is lower than 30°C, high speed is selected. Your unit will choose the mode to be run according to the room temperature: If T 20°C, heating mode. TIMER: To turn on the unit automatically, press TEMPS (M) when the unit is plugged but not running. Remaining time before starting is displayed on VFD screen and adjusted every half hour. To turn off the unit automatically, press TEMPS (M) when the unit is running. Remaining time before stopping is displayed on VFD screen and adjusted every half hour. [. . . ] Anti dust air filter: If the anti dust air filter is dirty, the air conditioner will be less performing. Before asking for repair service, please check: Problems Unit does not work Causes - It is not plugged in - Socket or plug is damaged - Fuse or power cord are damaged Suggest solution - Plug in - Change it - Make it repair by a qualified person Unit stops working automatically - Room temperature is higher than set temperature - Condenser is frosted - The unit is pre-heating Normal symptom Eliminate frost Normal symptom: after pre-heating, unit will start working - Voltage is too high or too low - Unit is damaged When there is something wrong with your unit, contact a qualified person. Instructions on environment protection Do not dispose of this product in the usual household garbage at the end of its life cycle ; hand it over a collection point for the recycling of electrical and electronic appliances. [. . . ]