User manual ALPATEC AC 122

[. . . ] ⷠAlways place the appliance in a vertical position, in order to maintain the compressor in good working conditions. ⷠNever let the appliance in a room with children and handicapped people without supervising. ⷠDo not use outdoor, in a wet environment, close to a bath-tub, a shower or a swimming pool. ⷠDo not immerse appliance or power cord · This product is provided with its own power cord. [. . . ] Do not use any other electrical connection but the one supplied and recommended by the manufacturer. ⷠDo not use if power cord or appliance is damaged · Only use this appliance for domestic purpose, following the instructions of that manual. ⷠIn order to avoid any electrical interference, keep away from electric sources. ⷠDo not use if it is not totally assembled and particularly if the protection grid is not secured, or the exhaust pipe is not assembled. 1 ETP Rotary compressor Maximum cooling capacity Nominal cooling input power Heating capacity Dehumidifying capacity Air flow Noise level min. ⷠAfter unpacking, place the unit upright to allow the cooling agent to stabilize and wait 3 hours before use. Fit the supplied round window connector on the air outlet duct then let it get through the wall. When mounting, we advise to keep the exhaust pipe in a horizontal position. The bend of the exhaust pipe is too important and can occur a wrong working of the unit. Take off the water stopper and the rubber plug of the drain hole, the condensed water will go automatically into the tray. When the water tray is almost full replace the rubber plug of the drain hole and the water stopper. Do the operations 2 ­ 3 ­ 4 again until there is no more water in unit. Check there is no power more into the unit before any maintenance or repairing operation, in order to avoid any electric shock. ⷠDo not use chemical solvent (like benzene, alcohol glazer) to clean the surface of the unit. If you do so, the surface will be scratched, damaged even the whole casing could become deformed. Clean the air filter regularly (every two weeks) for an optimum air flow. Use a vacuum cleaner or tap the filter lightly to remove dust and then rinse thoroughly under running water (lukewarm water). Make the unit working in fan mode about a couple of hours, so that the inside part of the unit can completely dry. [. . . ] Make the unit working in fan mode about a couple of hours, so that the inside part of the unit can completely dry. Replace the unit in its original packing and do not stock heavy objects of the top of the appliance. ⷠWhen the appliance is not in use put the power cord away as shown in picture beneath. Check first the symptoms following before calling a qualified electrician. [. . . ]