User manual ALPATEC AC 105.1 ETP

[. . . ] cAUTIONS When using electrical appliances, some rules have to be respected. Take care to install this product by complying with the national rules of electric installation. [. . . ] Do not replace or prolong with your own private hose as this could cause the unit to mal-function. 1- Set temperature indicator 2- Room temperature indicator 3- Low fan indicator 4- High fan indicator 5- Automatic mode indicator 6- Cooling mode indicator 7- Dehumidifying mode indicator 8- Heat mode indicator 9- Timer mode indicator 10- Running mode indicator 11- "+" temp key 12- "-" temp key 13- Fan speed key 14- Mode key 15- PROG key 16- ON/OFF key 17- Set temperature/hour display 18- Remote control signal receiver Press the on/off key (a or 16), the unit starts automatically in the last mode used. Automatique mode: if the ambient temperature is lower than 23°C, the appliance will work in heating mode and if the ambient temperature is higher than 23°C it will work in cooling mode. Cooling mode: if the ambient temperature is lower than the required temperature, the appliance will fan only and if the ambient temperature is higher than the required temperature, it will work in cooling mode. Heating mode: if the ambient temperature is higher than the required temperature, the appliance will fan only and if the ambient temperature is lower than the required temperature, it will heat. In cooling mode, set temperature will increase 1°C every hour for two hours, in heating mode it will decrease 1°C every hour for two hours. Press on the key (11) or (12) of the control panel or the key (d) on the remote control to set the desired temperature from 16° to 30°C (1 pressure = 1°C). ⷠThe temperature of the unit is selected first to 24 °C for the cooling mode. Press the fan speed key (13-c) to choose the desired fan speed : low or high. ⷠOn automatic mode function, the unit will automatically choose the fan speed according to the room temperature (the speed indicators will light up). To prolong the life of the compressor, after switching off the unit, wait for 3 minutes minimum before plugging it again. ⷠYour unit must always be used in an upright position because it contains a cooling agent. During the cooling process, water is extracted from the air into the unit. When the water tray of the unit is full, the compressor stops, the fan only continues to run. [. . . ] Then contact a qualified electrician if the problem lasts or as soon as something abnormal occurs. Instructions on environment protection Do not dispose of this product in the usual household garbage at the end of its life cycle ; hand it over a collection point for the recycling of electrical and electronic appliances. [. . . ]