User manual ALINCO DJ-F1T

[. . . ] Use appropriate tool The intended use is described in this instruction manual. Do not force small tools or attachments to do the job of a heavy-duty tool. The tool will do the job better and safer at the rate for which it was intended. The use of any accessory or attachment or performance of any operation with this tool other than those recommended in this instruction manual may present a risk of personal injury. [. . . ] Only use router bits with a shank diameter equal to the size of the collet installed in the tool. Never use router bits with a diameter exceeding the maximum diameter specified in the technical data section. Take special care when routing MDF or surfaces coated with lead-based paint: - Wear a dust mask specifically designed for protection against lead paint dust and fumes and ensure that persons within or entering the work area are also protected. Additional safety instructions for Australia and New Zealand x This appliance is not intended for use by young or infirm persons without supervision. Children must be supervised to ensure they do not play with the appliance. X If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorised repair agent or a qualified electrician. Disconnect the plug from the supply and remove the fuse from the plug. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). X Pull the plunge lock lever (4) up and let the router return to its original position. X After switching the router on, plunge it down and make the desired cut. H) After turning the revolver depth stop to the desired setting, you can fine-adjust the depth stop to be used. If you want to make several cuts with a different depth of cut, adjust each of the depth stops. X Turn the depth stop screw (19) up or down as required using a screwdriver. I) When it is not possible to use the edge guide, for example when routing grooves in the back panel of a bookcase to support shelves, proceed as follows: x Place a batten onto the workpiece. X Move the batten until it is in the correct position to guide the tool. M) The template guide can be used to make a cutout shape from a template, for instance a letter. The router bit must extend below the flange of the template guide, to cut the workpiece in the shape of the template. N) The distance piece can be used for trimming wooden or laminate vertical projections. X The router can now be moved over the workpiece to cut out the circle. [. . . ] Technical data Voltage (Australia & New Zealand) Power input No-load speed Collet size Max. 3 To claim on the guarantee, you will need to submit proof of purchase to the seller or an authorised repair agent. You can check the location of your nearest authorised repair agent by contacting your local Black & Decker office at the address indicated in this manual. Alternatively, a list of authorised Black & Decker repair agents and full details of our after-sales service and contacts are available on the Internet at: www. [. . . ]