User manual ALINCO DJ-175

[. . . ] VHF FM TRANSCEIVER DJ-175 T/E/TFH Instruction Manual Thank you for purchasing your new Alinco transceiver. This instruction manual contains important safety and operating instructions. Please read this manual carefully before using the product and keep it for future reference. ALINCO, INC. NOTICE / Compliance Information Statement NOTICE / Compliance Information Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Select the frequency that you wish to operate by using the dial or the keypad. When a signal is received on the frequency that you selected, and S-meter are displayed on the LCD, then the received signal can be heard. The green RX indicator also lights at this time. 4 4. 7. 1 Monitor Function In case the receiving signal is weak and the audio is intermittently cut off by the squelch, press the MONI key. As long as this key is pressed, the squelch including TSQ/DCS unmutes making the audio easier to hear. · The squelch is unmuted while the MONI key is pressed, regardless of the squelch level setting. · This function unmutes the squelch even if the DCS and Tone Squelch functions are set. 4. 8 Transmitting 1. While holding down the PTT key, speak into the unit at normal voice from the distance of 5cm (2"). Release the PTT key to receive. IMPORTANT NOTE: · To transmit a tone-burst signal, press the MONI key while holding down the PTT key. · Speaking too loud, too close or too far from the unit may distort the audio. · "OFF" appears on the display and a beep sounds when the PTT key is pressed with the TX frequency set out of the TX range. You can not transmit in this state. 28 4. Basic Operation 4. 8. 1 Selecting the Output Level Press the FUNC key, and while is displayed on the LCD, press the key to switch transmission power output. The display changes as follows depending on the output level selected: · is displayed with on the power meter. (Middle power output) · Nothing is displayed with on the power meter. IMPORTANT NOTE: The output level can't be altered while transmitting. 4 29 5. Useful Functions 5. Useful Functions 5. 1 Scan Modes The scan function automatically searches the receiving signals. · Busy Scan: The scan stops when a signal is detected, stays until the signal is gone then resumes scanning. · Timer Scan: The scan stops when a signal is detected, and resumes scanning after 5 seconds regardless of receiving status. During scanning, the 1MHz decimal point ( ) on the frequency display flashes. Scanning starts in the direction of the last dial operation (up or down). 5 NOTE: Please refer to the Set mode to switch the setting between Timer and Busy scan modes (page 42). 5. 1. 1 VFO-Scan 1. Rotate the dial clockwise/counter-clockwise to change the scan direction. Press any key other than the MONI key to stop scanning. 5. 1. 2 Memory-Scan 1. Rotate the dial clockwise/counter-clockwise to change the scan direction. [. . . ] Please charge the pack completely before use. Available Battery Packs for DJ-175 EBP-71 EBP-72 Li-ion Battery Pack (DC 7. 4V 1200mAh) Ni-MH Battery Pack (DC 7. 2V 700mAh) Charging Battery Packs Refer to the chart below for the combination of the proper battery pack and charger. The indicates the usable combination, (* hrs) means the approximate time necessary to full charge the empty pack. Battery Packs Chargers EDC-164 EDC-165 Li-ion Battery Pack EBP-71 (2. 5hrs) Ni-MH Battery Pack EBP-72 (10hrs) 10 52 10. Maintenance and Reference 10. 3. 2 Using the Chargers Caution Please also read the "Warning" (page 4 of this manual) and the safety instruction that is included in the accessories' package before operating for your safety. Charging with the EDC-165 (Trickle Charger) Please make sure that following items are included in the package. · EDC-165T: EDC-165 basket, EDC-146 adapter (AC 120V), insulation sheet · EDC-165E: EDC-165 basket, EDC-147 adapter (AC 230V), insulation sheet · EDC-165UK: EDC-165 basket, EDC-148 adapter (AC 230V), insulation sheet *Standard accessories may vary depending on the models you have purchased. Connect the AC adapter plug to the DC-IN jack on the back of the basket. [. . . ]