User manual ALESIS JP QCARD

[. . . ] Switch everything on in the following order: · Computer When turning off, always reverse this operation by: · 0 be turned off before connecting and disconnecting any sources to the inputs of the unit. AUX B: Controls level routed to internal effects processor or ­ if a device is patched into the Aux B returns ­ routes channel signal to an external device like an effects processor. [. . . ] AUX B: Controls level routed to internal effects processor or ­ if a device is patched into the Aux B returns ­ routes channel signal to an external device like an effects processor. 0, the MONO channels' pan position is ignored when recording the individual channel but is captured when recording the MAIN MIX channels. EFFECTS/AUX RET B: Controls the signal level of the internal effects or the level returning from AUX B if in use. USB/2TK TO MIX: Routes the stereo return from the computer as well as the 2TK input to the MAIN faders. USB/2TK TO CTRL ROOM: Routes the stereo return from the computer as well as the 2TK input to the HDPH /CTRL RM output. 0 allows you to record every individual channel to the computer, along with the main mix. 0 Connect your output devices - headphones or speakers, or both - to the MultiMix USB 2. 0 and your computer Turn your computer on NOTE: If your computer "hangs" when following this procedure, turn off both the mixer and the computer. 0 to achieve a strong signal which does not distort (clip) Use the equalizer to sculpt the sound To record the signal along with the built-in effects or AUX bus effects, record the master fader signal. individual channel signals include EQ but do not include effects On the MultiMix USB 2. 0, assign the "2-TK" output from the computer to the monitor mix Raise the monitoring level (headphones or monitor speakers) on the MultiMix USB 2. 1 port) Windows XP (with Service Pack 2 or higher installed) or Vista (32-bit) 5400 RPM or faster hard drive recommended for multitrack audio 0 support (2 tracks in and out at 44. [. . . ] individual channel signals include EQ but do not include effects On the MultiMix USB 2. 0, assign the "2-TK" output from the computer to the monitor mix Raise the monitoring level (headphones or monitor speakers) on the MultiMix USB 2. [. . . ]