User manual ALESIS CI+ QCARD

[. . . ] Make sure all items listed on the front of this guide are included in the box. Make sure all input devices such as microphones, CD players, mp3 players, and linked amplifiers/PAs are turned off and volume settings are set at "zero" Connect all devices as shown above. [. . . ] connect the stereo outputs to the power amplifier(s) , tape decks , and/or audio sources. When turning off, always reverse this operation by: · Turning off amplifiers Transactive Mobile last, any input devices Go to http://www. Microphone 1 Balanced Input with Gain Control (1/4" and XLR): This jack can either take a ¼" balanced or a XLR balanced cable. Instrument/Microphone 2 Input with Gain Control (1/4"): This mono input accepts a ¼" input such as a microphone, guitar, or other musical instrument. IPod/Auxuliary input with Gain Control (Stereo RCA): This knob controls the level of the iPod* and the RCA input. Use this troubleshooting guide if: The sound is distorted at high volumes. Input is clipping: Try lowering the input gain or the volume control on your sound source or music instrument. There is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass level. This will allow you to play the music louder before clipping (distortion) occurs. The link cable: is being plugged into the instrument or MIC input instead of the RCA line input. [. . . ] This will allow you to play the music louder before clipping (distortion) occurs. The link cable: is being plugged into the instrument or MIC input instead of the RCA line input. [. . . ]