User manual ALCHEMIST KRAKEN APD8A

[. . . ] All functions are duplicated on the Product 8 Integrated Amplifier remote handset (except Power). You will probably find that the maximum usable volume will be attained at approximately two o'clock position on the volume control (See Loudspeaker Matching) POWER: This will allow the Product 8 Integrated Amplifier to be either fully powered up or completely switched off. When the unit is first powered up it will revert to the volume to zero and select input 1. [. . . ] When the unit is first powered up it will revert to the volume to zero and select input 1. MUTE: Once the Product 8 Integrated Amplifier has been initially switched and powered up, this function will allow you to toggle between; normal listening and mute. INPUTS SELECTORS: These determine the source component to be listened to. These selections are also controlled by the Product 8 Integrated Amplifier remote handset. REMOTE HANDSET The Product 8 Integrated Amplifier comes supplied with a full function handset. It requires one CR2032 3V battery (supplied) to operate and the functions are as follows: IR Transmitter Power Standby (not used on PRODUCT 8 Integrated) Volume Up Input Channel Up/Down Volume Down Tape Monitor R T (not used on PRODUCT 8 Integrated) Reset M (not used on PRODUCT 8 Integrated) Mute Battery replacement type: 3V CR2032 Replace with same type only SOURCE CONNECTIONS Be sure that your amplifier is switched off when connecting or disconnecting any leads. As the phono sockets on the Product 8 Integrated Amplifier are gold plated, we recommend that, where possible, you use gold phono plugs on your interconnect leads. Gold to gold connections will ensure that a good electrical contact is maintained without the need for periodic cleaning. If you fail to observe this pattern your system may result in an `out of phase' condition, giving you poor results in sound quality. LOUDSPEAKER MATCHING The most common misunderstanding in matching amplifiers with loudspeakers is with power handling. When amplifiers are given a power rating, this refers to the maximum output. The maximum usable output will usually be reached at about 1 - 2 o'clock on the volume control, leaving enough reserve power to cope with transients and crescendo's. This limit is also dependant on such things as source output levels and loudspeaker sensitivity. If an amplifier is driven beyond this limit it will 'clip' (literally clipping the wave form), resulting in distortion. It is this distortion that usually damages loudspeakers, and not a mis-match in power ratings. If you are in any doubt about the suitability of your amplifier to drive your loudspeakers, please consult your dealer. [. . . ] It is this distortion that usually damages loudspeakers, and not a mis-match in power ratings. If you are in any doubt about the suitability of your amplifier to drive your loudspeakers, please consult your dealer. Please note that, as with all hi-fi products, there are no user-servicable parts inside. [. . . ]