User manual ALCHEMIST KRAKEN APD7A

[. . . ] Under no circumstances must the unit become covered as this may result in the unit overheating. If you are bridging two Product 8 Power Amplifiers do not stack them. PRODUCT 8 POWER AMPLIFIER POWER MAINS POWER CONNECTION The Product 8 Power Amplifier comes with an IEC mains lead fitted with the relevant plug type for the country of use. [. . . ] There is an external replaceable fuse on the rear of the unit: refer to specifications for fuse value. Be sure that your system is switched off whilst connecting / disconnecting any leads. PRE-AMP CONNECTION Please note that we do not supply interconnect leads as most people like to choose their own. Unbalance (RCA) leads should not be more than 3 metres long, and balance (XLR) leads can be any length. Normal Stereo Configuration (Using one Product 8 Power Amplifier) The Product 8 Power Amplifier can be used in stereo mode with any model of pre-amp, although we recommend the Product 8 Per Amplifier for optimum performance. The connection can be done in either through unbalance RCA or balanced XLR connection. The cables should connect the Product 8 Power Amplifier `preamp input' with the `preamp output' on the Pre amplifier. When amplifiers are given a power rating, this refers to the maximum output. The maximum usable output will usually be reached at about 1 - 2 o'clock on the volume control, leaving enough reserve power to cope with transients and crescendo's. This limit is also dependant on such things as source output levels and loudspeaker sensitivity. If an amplifier is driven beyond this limit it will 'clip' (literally clipping the wave form), resulting in distortion. It is this distortion that usually damages loudspeakers, and not a mis-match in power ratings. If you are in any doubt about the suitability of your amplifier to drive your loudspeakers, please consult your dealer. GENERAL CARE Any cleaning of your PRODUCT 8 Power Amplifier should be done with a clean dry cloth or soft bristle brush. [. . . ] There is no need to polish the gold effects, a simple dry wipe is sufficient. Do not use any solvent or silicone based cleaning solutions as this may result in tarnishing. [. . . ]