User manual ALCHEMIST FORSETI ADP20A

[. . . ] Under no circumstances must the unit become covered as this may result in the unit overheating. It is advised that not to stack the Product 8 Multi-Channel Power Amplifier with other products. PRODUCT 8 MULTI-CHANNEL POWER AMPLIFIER POWER MAINS POWER CONNECTION The Product 8 Multi-Channel Power Amplifier comes with an IEC mains lead fitted with the relevant plug type for the country of use. [. . . ] If there is any need to change this then follows the relevant instructions for the plug type used. There is an external replaceable fuse on the rear of the unit: refer to specifications for fuse value. Be sure that your system is switched off whilst connecting / disconnecting any leads. SOURCE CONNECTION Please note that we do not supply interconnect leads as most people like to choose their own. Unbalance (RCA) leads should not be more than 3 metres long, and balance (XLR) leads can be any length. The Product 8 Multi-Channel Power Amplifier can be used with any model of Audio/Video sound processor with up to 5 channels outputs. The connection can be done in either through unbalance RCA or balanced XLR connection. LOUDSPEAKER CONNECTION As with all connections ensure that the equipment is switched off before you attempt to connect any cables. This limit is also dependant on such things as source output levels and loudspeaker sensitivity. If an amplifier is driven beyond this limit it will 'clip' (literally clipping the wave form), resulting in distortion. It is this distortion that usually damages loudspeakers, and not a mis-match in power ratings. If you are in any doubt about the suitability of your amplifier to drive your loudspeakers, please consult your dealer. GENERAL CARE Any cleaning of your PRODUCT 8 Multi-Channel Power Amplifier should be done with a clean dry cloth or soft bristle brush. There is no need to polish the gold effects, a simple dry wipe is sufficient. Do not use any solvent or silicone based cleaning solutions as this may result in tarnishing. [. . . ] There is no need to polish the gold effects, a simple dry wipe is sufficient. Do not use any solvent or silicone based cleaning solutions as this may result in tarnishing. [. . . ]