User manual ALCATEL 29446 CE

[. . . ] 4) Do not use this product near water (for example, near a bath tub, kitchen sink, swimming pool). 5) Do not expose the telephone to direct sunlight or extreme cold environment. Do not put the telephone close to a heating source such as radiators, cookers, etc. 6) Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock. [. . . ] Adjust Handsfree Volume There are 5 levels (VOLUME 1 to VOLUME 5) to choose from for each of headset and handsfree volume. When you end the call, the setting will remain at the last selected level. Barge in a call / Call transfer Function is enabled for the limited bundle package (29446 CE + Versatis XL350, 29446 CE + Versatis XL350 Voice) only. When your telephone (Versatis XL 350 or Versatis XL350 voice) is in conversation you can join the call by pressing key of the 29446 CE. Then, when you end the call using the XL 350 or XL 350 voice handset during “barge in call” mode, it will transfer the call to the 29446 CE automatically. End a Call During a call connection, press either key OR put the Alcatel 29446 CE on the charger to end the call. . 4. 8. Intercom You can use another registered handset on the same base station. Phone settings Your 29446 CE comes with a selection of settings that you can change to personalize your Alcatel 29446 CE the way you like it to work. Base Charger Use your mobile phone to dial in the telephone number that Alcatel 29446 CE is connected to, then answer the call with the Alcatel 29446 CE by pressing key to enter communication mode. Then, your mobile phone are in communication with the Alcatel 29446 CE and ready for programming. To do setting, always start with and terminate with # using your mobile phone keypad. When entering the key using your mobile phone keypad, the LED of Alcatel 29446 CE will remain on blue, i. e. It is recommended that you avoid using this device during electrical storms. Do not attempt to open the batteries, as they contain chemical substances. In the event of leakage, avoid contact with the skin, eyes, nose and mouth. In the event of contact, rinse the affected part for about twenty minutes with running water and seek urgent medical attention. Clean the product with absorbent paper or a dry cloth and contact your reseller for replacement batteries. ATLINKS hereby declares that the following models conform to the essential requirements and other applicable provisions of European directive 1999/5/EC. Alcatel 29446 CE Reset all parameters to default (see press " 07" + pin number +"#" (complete by hearing a confirmation tone ) remark under table 1) Manual registration Change registration PIN code Long press key and confirmation tone). for 3 seconds at the same time (complete by hearing a Press " 22" + pin number +"#" (complete by hearing a confirmation tone ) You can change Pin number to 4 digits number. The default Pin number is “0000”, 4 digits in length. Remark: To reset all previous parameters to default settings, you can do it from the Alcatel 29446 CE itself. 1) Ringer volume reset to level 3, 2) Ringer melody to 3, 3) All 3 memories to empty. TABLE 2: COLOR OF LED INDICATION LED Color Red Behavior Blink Rapid Blink Blue Blink Steady On Violet Blink Steady On Steady On Description Charging (always on even if Battery is full) Unregister Mode Out of range During Power On, or Idle mode (per 32 seconds), or Incoming call, or In Use (remark: speed of blink is slightly different in each above conditions) Programming mode Registration mode, or Low Battery level Reset Mode ENVIRONMENT This symbol means that your inoperative electronic appliance must be collected separately and not mixed with the household waste. [. . . ] - If you are a professional user, please follow your supplier's instructions. - If the appliance is rented to you or left in your care, please contact your service provider. Keen to preserve the environment, ATLINKS has equipped this appliance with a switching power supply, offering better energy efficiency. The advantages include not only very low electricity consumption, but also a more compact format than the conventional power supply units used by the previous range. [. . . ]