User manual AL-KO LHS5500

[. . . ] Wear protective gloves Safety measures Only one person is permitted to operate the log splitter. Clothing should be practical (close fitting) and should not hinder the wearer. The log splitter should only be operated when it is assembled completely and both the log splitter and connection cable are free of damage. damaged protective fittings should only be replaced by a specialist firm or workshop. [. . . ] Is prohibited Operation in potentially-explosive atmospheres is not permitted Any other utilisation above or beyond correct use is prohibited. A) 1 2 3 4 5 6 7 8 9 10 11 12 13 Transportation handle Splitting blade Control arms with levers and hand guards Splitting table Hydraulic oil tank Stand feet Motor Switch/Plug socket combination Splitter column Swivel table Engaging lever on swivel table Splitting cross Securing rubber bands GB 2 Log splitter Unpacking/Assembly Caution!The log splitter should only be used when all its component parts have been completely assembled. Note: Check the direction of rotation of the motor in the case of a log splitter with a three-phase current motor (LHS 7000). The direction of rotation should correspond to the arrow on the fan cover. A polarity reversal should be realised in the plug with the phase inverter if this is not the case. Press in the phase inverter in the plug with a straight screwdriver and turn through 90° (see Illus. Establish the power supply and check the direction of rotation of the motor again. Insert the control arm and tube in the transverse connection recess (Illus. Insert the retaining pin from above past the tube to the left and secure below with the washer and split pin (Illus. The protective hoops) are missing or defective or the connection cable is damaged. Adjusting the retaining claws The retaining claws can be adjusted to suit the diameter of the timber. Loosen the star grip on the retaining claw and adjust longitudinally to suit the timber diameter (Illus. The log splitter should not be operated if components are missing, defective or loose. With cracks, cuts, crushing damage or bends in the insulation) should not be used. Mount the splitting cross and screw the fixing screw into the recess in the splitting blade to draw the splitting cross upwards completely. Lay the connection cable so that it cannot be damaged by bending, crushing or otherwise. Loosen the star grips from the housing, unfold the feet outwards, securing them with the star grips. This prevents the motor from starting again spontaneously in the event of a power cut. The motor can only be restarted by pressing the green activation button. gB 3 Translation of original user instructions Log splitter 4. Set the splitting table at the level of the timber to be split (see Illus. [. . . ] Move the splitting blade completely downwards and switch off the motor. Malfunction Cause Malfunctions Switch off the log splitter and pull out the mains power plug in the event of malfunctions occurring. Engage a specialist firm or workshop to remedy malfunctions that cannot be rectified on the basis of the following table. Remedy The splitting column does Motor rotation direction is incorrect Check direction of rotation not move out/in (in case of LHS 7000) Too little hydraulic oil Top up hydraulic oil The splitting blade does Too little hydraulic oil not exert any force Trigger rod is bent Motor does not start Thermostatic switch has tripped Top up hydraulic oil Have checked workshop by specialist Wait until the motor has cooled down. [. . . ]