User manual AL-KO KHS5200

[. . . ] damaged protective fittings should only be replaced by a specialist firm or workshop. The log splitter should be disconnected from the mains power supply for: − service work − adjustment work − transportation − brief work interruptions. Repairs to the log splitter should only be realised by a specialist firm or workshop. Do not operate the log splitter if uninvolved persons are in the close vicinity. [. . . ] Disconnect the connection cable immediately from the mains power supply. incorrect use − − − Splitting of timber containing metal components such as nails , wire , metal braces , etc. Is prohibited Operation in potentially-explosive atmospheres is not permitted Any other utilisation above or beyond correct use is prohibited. A/B) Protection cover Log pusher Log guide tubes Splitting wedge Piston rod Transportation bracket ON/OFF switch on electric motor Operating lever Rear feet (only KHS 5200) Support foot (only KHS 5200) Park position transport wheels (only KHS 5200) 12 Front feet (only KHS 5200) 13 Front cross member (only KHS 5200) 1 2 3 4 5 6 7 8 9 10 11 GB 2 GB Unpacking/Assembly Caution!The log splitter should only be used when all its component parts have been completely assembled. The protective hoops) are missing or defective or the connection cable is damaged. The log splitter should not be operated if components are missing, defective or loose. With cracks, cuts, crushing damage or bends in the insulation) should not be used. Position the log splitter horizontally on a level, firm surface, better with a slight inclination towards the operating lever (since the valves are seated here). Lay the connection cable so that it cannot be damaged by bending, crushing or otherwise. The transportation wheels with model KHS 5200 are only used to transport the log splitter. During splitting operation, the wheels must be removed from the feet and mounted in the park position. Depending on the length, lay the log such that the wooden log is held by the log guide tubes. Never force the splitting of a log by sustaining the hydraulic pressure over several seconds. Mount the transportation wheels on both the front feet; see Section “Mounting the transport wheels. The transportation wheels are only used to transport the log splitter. During splitting operation, the wheels must be removed from the feet and mounted in the park position (Illus. Tilt the log splitter on to one side and mount the front and rear foot. 2-1 and 4-1) and secure it firmly in position with screws , washers , and locking nuts. Tilt the log splitter onto the opposite side with the help of a second person, and mount the other feet and afterwards put it upright. Put the log splitter in vertical position (piston rod upright) and screw the support foot (illus. Erect the log splitter and mount the cross members in front (Illus 5-1) with the help of the threaded rod (Illus. [. . . ] Malfunction Cause Remedy Top up hydraulic oil The log pusher does not move Too little hydraulic oil out/in Hydraulic pump is defective Replace hydraulic pump The splitter is inclined towards the splitting Position the splitter on a horizontal plane or wedge inclined towards the operating lever The log pusher does not exert Too little hydraulic oil any force Top up hydraulic oil The splitter is inclined towards the splitting Position the splitter on a horizontal plane or wedge inclined towards the operating lever Hydraulic pump makes a Too little hydraulic oil Top up hydraulic oil whistling noise, the log pusher moves with a jerking motion The splitter is inclined towards the splitting Position the splitter on a horizontal plane or wedge inclined towards the operating lever Air inside the circulation system Motor becomes excessively hot Motor is not starting Cable cross section is too small Thermostatic switch has switched off Mains plug or socket is defective Cable is defective Electric motor is defective Open the venting screw Use cable with larger cross section Wait until the motor has cooled down Let an electrician check the plug Replace by an electrician Let an electrician check the motor Environmental protection, disposal Do not dispose of old units in household waste!The packaging, unit and accessories are made of materials that can be recycled and should be disposed of in a suitable manner. Priključno napeljavo položite tako, da ne more biti preganjena, zmečkana ali se na drug način poškodovati. Hold arbejdsområdet frit for træstykker og andre genstande – fare for at snuble. [. . . ]