User manual AKG SR 40

[. . . ] Before connecting the equipment to power, check that the AC mains voltage stated on the supplied AC adapter is identical to the AC mains voltage available where you will use the equipment. Using adapters with a DC output and/or a different output voltage may cause serious damage to the unit. If any solid object or liquid penetrates into the equipment, shut down the sound system immediately. Disconnect the AC adapter from the power outlet immediately and have the equipment checked by AKG service personnel. [. . . ] VOLUME: This rotary control adjusts the SR 40's output level from microphone to line level for matching to the input sensitivity of your mixer or amplifier. If no signal is received or the squelch is on, the RF LED goes out and the audio output is muted. color Code: The color indicates the carrier frequency of your receiver. Transmitters tuned to the same frequency are marked with identical colors. 375 MHz MHz MHz MHz MHz MHz MHz MHz MHz MHz reddish brown purple mint green dark gray Bordeaux red yellow violet green melon yellow gray Received signal is too weak, in order to suppress the related noise or the residual noise of the receiver while the transmitter is off. Prior to setting up your WMS 40, check that the transmitter and receiver are tuned to the same frequency. The easiest way to do this is to compare the color codes on the transmitter and receiver. Make sure, though, that the transmitter will never get any closer to the receiver than 10 ft (3 m). Check that you can see the receiver from where you will be using the transmitter. You can either use the receiver freestanding or mount it in a 19" rack using the optional RMU 60 rack mounting kit. Slide the two supplied side panel moldings (13) with the rubber feet facing up into the fixing rails on both sides of the receiver from rear to front. Place a clamping slide (14) on each rack ear (29), checking that the pegs on the clamping slides (14) engage in the fixing holes on the rack ears (29). Slide the clamping slides (14) and rack ears (15) into the fixing rails on both sides of the receiver from rear to front. Tighten the two Phillips screws in the clamping slides (14) CW to fix the rack ears (15) on the receiver. Use the supplied screws to fix the supplied blank panel to the left or right rack ear (29). Fix one rack ear (15) to the outside panel of each receiver referring to steps 1 through 3 above. Insert a clamping slide (14) with no rack ear (15) into the fixing rails on the INSIDE PANEL of one receiver. Insert the receiver with the clamping slide (14) on its inside panel into the fixing rails on the inside panel of the other receiver. Tighten the two Phillips screws in the inside clamping slide (14) CW to connect the two receivers. use a standard XLR cable to connect the MIC OUT connector (7) on the receiver rear panel to a balanced XLR microphone input on the mixer. Turn the VOLUME control (3) on the receiver all the way CCW to set the receiver output to microphone level. Use a standard 1/4" jack cable to connect the LINE OUT jack (8) on the receiver rear panel to an unbalanced 1/4" line input jack on the mixer. [. . . ] Remedies: Switch power to the transmitter ON, move closer to the receiver, or turn the SQUELCH control (12) CCW to the point that the RF LED (4) will come back on. Connect AC adapter to ed to receiver and/or power receiver and/or power outoutlet. Connect microphone or is not connected to bodyinstrument to audio input pack transmitter. Use receiver and transcolor codes are not mitter with identical color identical. [. . . ]