User manual AKG SR 4500

[. . . ] If you will not use the equipment for a long period of time, disconnect the AC adapter from the power outlet. Please note that the equipment will not be fully isolated from power when you set the power switch to OFF. Do not place the equipment near heat sources such as radiators, heating ducts, or amplifiers, etc. And do not expose it to direct sunlight, excessive dust, moisture, rain, mechanical vibrations, or shock. [. . . ] The AC adapter will draw a small amount of current even when the equipment is switched off. To save energy, disconnect the AC adapter from the power outlet if you will leave the equipment unused for a long period of time. When scrapping the equipment, separate the case, circuit boards, and cables, and dispose of all components in accordance with local waste disposal rules. This Manual contains important instructions for setting up and operating your equipment. Please take a few minutes to read the instructions below carefully before operating the equipment. ) 2-conductor shielded cable w/male and female XLR connectors The SR 40 diversity is a stationary diversity receiver for use with all WMS 40 and microtools Series transmitters. the SR 40 operates on one fixed , quartz stabilized frequency in the 710 MHz to 865 MHz UHF carrier frequency range and features a half-rack case. The SR 40 diversity is a diversity receiver and uses two antennas in order to receive the transmitter signal at two different spots. the diversity electronics will automatically activate the antenna that delivers the better signal. A preset squelch will mute the receiver if the received signal is too weak so the related noise or the self-noise of the receiver will not become audible when the transmitter is switched OFF. If the RF/OK, AF/OK, and only one of the two DIVERSITY LEDs illuminate, the receiver is ON and receives signal. Screw a short bracket to the outer side panel of each receiver using for each bracket two of the screws you removed from the receiver side panels. use a standard XLR cable to connect the BALANCED connector on the receiver rear panel to a balanced XLR microphone input on the mixer. Turn the VOLUME control on the receiver front panel all the way CCW to set the receiver output to microphone level. Use a standard 1/4" jack cable to connect the UNBALANCED jack on the receiver rear panel to an unbalanced 1/4" line input jack on the mixer. Turn the VOLUME control on the receiver front panel all the way CW to set the receiver output to line level. Use a standard 1/4" jack cable to connect the UNBALANCED jack on the receiver rear panel to an unbalanced 1/4" line input jack on the amplifier. Turn the VOLUME control on the receiver front panel all the way CW to set the receiver output to line level. Check that the AC mains voltage stated on the supplied AC adapter is identical to the AC mains voltage available where you will use your equipment. Using the AC adapter with a different AC voltage may cause irreparable damage to the unit. Bend part of the feeder cable into a small bight, pass the bight through the strain relief from above, and place the end of the bight snugly against the hook on the strain relief . Press the front panel POWER switch to switch power to the receiver ON. [. . . ] , places where the field strength seems to drop and reception deteriorates. If you find any dead spots, try to eliminate them by repositioning the receiver. Make sure there will always be a direct line of sight from the transmitter to the receiver. The RF/OK LED on the receiver going out means no signal is received or the squelch is active. [. . . ]