User manual AKG HC 577 L

[. . . ] When scrapping the equipment, remove the batteries, separate the case, circuit boards, and cables, and dispose of all components in accordance with local waste disposal rules. To dispose of the packaging, make sure to use a collection/recycling system provided for that purpose and observe local legislation relating to waste disposal and recycling. This Manual contains important instructions for setting up and operating your equipment. Please take a few minutes to read the instructions below carefully before operating the equipment. [. . . ] The clear-Teflon moisture shield on the microphone prevents perspiration or makeup from clogging the sound entry ports and thus changing the sound and reducing the microphone's sensitivity. If you bend the parts too sharply they may break, which will void the warranty. Pull the microphone arm holder (2) with the microphone arm (3) from the temple piece (1) in the direction of the arrow. Slide the microphone arm holder (2) and cover (4) into the wire loops below the respective opposite temple pieces (1) to the point that they lock into place. (The cover (4) stabilizes the temple piece and prevents your hair from getting caught in the wire loop. Two Alternative Ways to Route the Cable a) To fix the cable more tightly inside the cable holder, you can reeve the cable through the cable holder twice. Make sure to leave enough slack in the rest of the cable so you can still readjust the behind-the-neck headband. B) Set the behind-the-neck headband to its smallest size and route the connector and cable through the behind-the-neck headband wires. Set the behind-the-neck headband to its largest size by pulling the two wires apart all the way. If necessary, slide the headband wires inward to the point that the microphone will rest securely yet comfortably on your head. Should the microphone still fit loosely even at its smallest size, you can bend the behind-the-neck headband and the temple pieces inward: If it does not, bend the wire some more, again with extreme care. Hold the temple piece firmly with one hand and lever the guide bush on the microphone arm out of the holder with the other hand. You can adjust the lateral distance between the microphone and your cheek by turning the microphone arm by the cable grip or by cautiously bending the microphone arm. When removing the microphone arm from the holder, never grasp the microphone arm itself!This alignment ensures optimum signal level and minimum pop 1 cm noise. If required for visual reasons, you may as well position the microphone capsule near the ear. To avoid distortion and pop noise, do not position the microphone capsule directly in front of your mouth! Always position the microphone capsule where it cannot touch your skin! [. . . ] The windscreen will be ready for use as soon as it has dried completely. Mouth and move microAlign microphone sound entriesjust far enough phone with corner of mouth and move and away from mouthmicrophone stop breath nose tojust far enough away noise. To order a free copy of the Declaration of Conformity, visit http://www. Par ailleurs, vous pouvez monter la mini-perche en un point quelconque dans son support ce qui vous permet de varier à volonté la distance du micro aux lèvres. [. . . ]