User manual AKG C 562 CM

[. . . ] Sound will move the diaphragms in opposite directions so the two output signals will add in phase. The microphone capsule is a patented design that prevents perspiration and moisture from penetrating into the transducer. A special clear plastic ring makes sure that perspiration and makeup will not clog the sound entries on the microphone body. [. . . ] An external windscreen supplied with the microphone reduces wind noise when using the microphone on an open-air stage. The C 562 CM is identical to the CK 77 WR, except that it operates on 9 to 52 V universal phantom power to DIN 45596/IEC 268-15 and is available in black only. ), with 3-pin mini XLR connector for use with AKG bodypack transmitters. ), with 3-pin mini XLR connector for use with AKG bodypack transmitters. Check what type of connector you need and solder the connector to the microphone cable. For details on connector wiring, refer to the instruction manual of the device to which you intend to connect your microphone. You can connect the CK 77 WR L and the CK 77 WR L/p to any AKG bodypack transmitter with a 3-pin mini XLR input. Using any power supply other than those recommended by AKG may damage your microphone and will void the warranty. Fix the microphone on the user's head, as close as possible to the mouth, and blend it in with the makeup. You can use the supplied adhesive compound or H 40/1 clip to fasten the microphone on various instruments (e. Since the microphone will sit very close to the sound source, you can set the gain control on the console to a rather low level. This means that the feedback risk in a live situation will be very low. To find the best position of the microphone on the instrument, try several different places on the instrument and compare the sounds. If you mount the microphone on a wind instrument, consider slipping the supplied W 77 windscreen on the microphone to reduce blowing noise. In theater work, the microphone grill and sound entry may become clogged by makeup and perspiration. Place the grill in an ultrasonic cleaning bath of the type jewelers use to clean jewelry. [. . . ] Place the grill in an ultrasonic cleaning bath of the type jewelers use to clean jewelry. This is the best way to clean even the smallest orifices in the grill. If the microphone fails due to condensation caused by perspiration after long periods of use on the body, you can replace the transducer element in the field. [. . . ]