User manual AKG C 516 ML

[. . . ] Please make sure that the piece of equipment your microphone will be connected to fulfills the safety regulations in force in your country and is fitted with a ground lead. For use with the B 29 L battery power supply, MPA V L phantom power adapter, or PT 40 or PT 400 bodypack transmitters. [. . . ] Before permanently mounting the microphone on your instrument or speaker cabinet, experiment with various microphone positions to get the best possible sound. Step 1: Fix the H 516 installation plate on your instrument or speaker cabinet (see a, b, or c below). To maintain the mechanical-noise attenuation of the rubber plate, do not tighten the screws hard enough to squeeze the rubber plate. â· Remove the backing paper from both sides of the rubber plate and press the rubber plate firmly on the bracket and then on the instrument or speaker. â· Use the supplied adhesive putty instead of the rubber plate. Both the rubber plate and the elastic putty provide the same amount of mechanical noise attenuation as the rubber eyelets on the H 516. Step 2: Slide the mounting plate (1) of the microphone into the H 516 installation plate (2) to the point that the mounting plate (1) audibly clicks into place. â· You can remove the microphone easily, for instance, in order to prevent it being damaged during shipping: pull the microphone out of the H 516 mounting plate. To mic up an accordion optimally, you will need two microphones, one for the bass and one for the treble range. If your instrument is big enough, you can even install the microphone inside the case, making sure to slip on the supplied W 44 windscreen to suppress the wind noise produced by the bellows. To keep the microphone cables out of your way, route them along the straps and from there to a B 29 L or two bodypack transmitters. Alternatively, you can mic up the accordion with a single C 516 ML and a stand-mounted microphone: 1. [. . . ] SPL for 1%/3% THD: Equivalent noise level: Power requirement: pre-polarized condenser microphone cardioid 60 Hz to 20, 000 Hz 5 mV/Pa (-46 dBV re 1 V/Pa) 200 ohms 2000 ohms 130/132 dB SPL 31 dB(A) to DIN 45412 B 29 L battery power supply, MPA V L phantom adapter, AKG WMS bodypack transmitters Cable length / Connector: 1. To order a free copy of the Declaration of Conformity, visit http://www. [. . . ]