User manual AKAI PDX2210I-TOP

[. . . ] Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer, or sold with the product. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer. A Product and Cart Combination Should Be Moved with Care - Quick stops, excessive force and uneven surfaces may cause the product and cart combination to overturn. VENTILATION - Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered. [. . . ] BATTERY CAUTIONS · Use only the size and type of batteries specified. · Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. · If the device in not to be used for a long period of time, it is required to remove the batteries to prevent damage or injury from possible battery leakage. · Do not try to recharge batteries which is not intended to be recharged; they can overheat and rupture. (follow battery manufacturer's directions) · Weak batteries can leak and severely damage the unit. · Always remove batteries as soon as they become weak. 4 · If the display shows the symbol " ", this means your batteries are weak, replace them or use the AC adaptor. · If the display is blank - no numbers show when power is turned on, the batteries are dead. CHARGING AND USE OF RECHARGEABLE BATTERIES This unit can fully recharge the specified rechargeable batteries, in approximately 15 hours. The rechargeable batteries (NOT supplied) should be recharged before they are used for the first time or they have not been used for a long period of time because they are low in power (over 60 days). Open the battery compartment cover and insert two of the recommended rechargeable batteries, matching polarity. ALL BATTERIES MUST BE OF RECHARGEABLE NICKEL-CADMIUM TYPE, OTHERWISE THE BATTERIES MAY EXPLODE OR LEAK. After 15 hours, please unplug the AC ADAPTOR and slide the recharge switch to "OFF" position. DOING SO CAN CAUSE THE PERFORMANCE OF THE RECHARGEABLE BATTERIES TO DETERIORATE. If the operating time decreases drastically even when the rechargeable nickel-cadmium batteries are properly recharged, purchase a new set of rechargeable nickelcadmium batteries. When charging for the first time or after a long time, playing time may be reduced. AUTO POWER ON FUNCTION The power turns on automatically when the PLAY/PAUSE button is pressed. AUTO POWER OFF FUNCTION The power turns off immediately after the disc compartment is opened. When all the tracks on a disc have been played, or the Stop button is pressed, the power turns off automatically within 30 seconds if no button is pressed. If you pressed the Stop button twice the power will turn off THE HOLD FUNCTION It is useful during playing, the function will lock the key on the panel to protect the mistake in the Playing. During playing slide the HOLD switch to "ON" position, the "HOLD" will appears in the display, the key on the panel will be locked, the panel key is disable. Slide the HOLD Switch to "OFF" position to stop the function. LISTENING WITH HEADPHONE (EARPHONE) Connect the plug of the stereo headphone (earphone) into the headphone jack (marked phones) before use the unit. [. . . ] Close lid securely (push down left corner of door) Take out the CD and leave the CD door open for about an hour to dry the moisture condensation. Disc will not play. CD door not closed. Moisture has condensed inside the CD deck. Headphone plug not inserted Re-insert headphone plug into the properly. No sound from headphones The volume control set to minimum Weak batteries. Tracks do not change or set does not play normally Batteries are too weak and the battery symbol will show in display Plug headphone into the headphone jack (not the line out jack). [. . . ]