User manual AKAI PDX2210

[. . . ] If the display is blank - no numbers show when power is turned on, the batteries are dead. CHARGING AND USE OF RECHARGEABLE BATTERIES This unit can fully recharge the specified rechargeable batteries, in approximately 15 hours. The rechargeable batteries (NOT supplied) should be recharged before they are used for the first time or they have not been used for a long period of time because they are low in power (over 60 days). Open the battery compartment cover and insert two of the recommended rechargeable batteries, matching polarity. [. . . ] To stop play, press the Stop Button, and the power turns off automatically after a while. · Press the · Press the to skip to the next track on the disc. · Press the FORWARD/REVERSE SEARCH ) button during play to scan the disc at high speed. Press and hold the skip ( ----forward ----reverse · If you press and hold the skip button ( playing track forward at high speed. · If you press and hold the skip button ( playing track backwards at high speed. ) while playing, it will scan the current ) while playing, it will scan the current BASS BOOST Use the Bass Boost function to increase the bass output when listening with headphones. During bass boost on setting, sometimes, you may hear some distortion, adjust the volume control to a lower level when using the bass boost feature. PROGRAMMED PLAY The tracks on the disc can be programmed for play in any order. (Up to 24 tracks can be programmed. ) During programming, "PROG" flashes in the display. Press the PROGRAM button again to enter the track into the memory. 3 4. Note: Programmed play will begins automatically if you program 24 tracks. "PGM" shows steady in the display and programmed play begins. The player stops automatically after all programmed tracks have been played. To check the program, press the STOP Button and then the PROGRAM button. THE CD MODE BUTTON This button can be pressed during play to accomplish many different kinds of play. 5 times for return to normal play. SINGLE TRACK REPEAT 1" will appear in the Press the CD Mode button once during play, and the " display. The current track will be played over and over again until Stop button is pressed. ALL TRACKS REPEAT/CONTINUOUS PLAY ALL" will appear in the Press the CD Mode button twice during play. The all tracks on disc will be played over and over again until Stop button is pressed. Note: If you press the button during playing, it will start the INTR play after the song finished. To stop the function, press the CD Mode button once more or press the Stop button. THE ANTI-SKIP MEMORY FUNCTION (10SEC. ) The digital anti-skip function uses semiconductor memory to prevent the sound from skipping when the unit is subjected to shocks and vibration during play. 4 1. When the ESP button is pressed during play, the indicator appears in the display and the digital anti-skip function turns on. The digital data equivalent to approximately 3 seconds (10 seconds) of music is stored in a read-ahead memory buffer before it is decoded and played. [. . . ] Sharp writing instruments, or the inks used in some felt-tip pens, may damage the surfaces of the disc. Always place the compact disc to the in the CD compartment with the label facing upward. Fingerprints should be wiped from the surface of the disc with a soft cloth. Tracks do not change or set does not play normally Batteries are too weak and the battery symbol will show in display Plug headphone into the headphone jack (not the line out jack). [. . . ]