User manual AKAI PDP4273M

[. . . ] OPERATING INSTRUCTIONS 42 Widescreen Plasma HDTV Monitor PDP4273M 1. Safety Guidelines Caution: Always use a power cable is properly grounded. Please use the AC cords listed below for each area: USA . . . . . . . . . . . . . . . . . . . . . CSA/cUL FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] Press SOURCE button to select VGA on the remote control. D-Sub(VGA) PC Audio INPUT Connecting the DVD player or HDTV Set-top box using Component input 1. Connect the YPbPr output of the DVD player or HDTV Set-top box to the YPbPr input of the PDP. Connect the audio output of the DVD player or HDTV Set-top box to the audio input of the PDP. Please ensure the Power Cord is connected and turned on the STANDBY button before it is operated. Press SOURCE button again to select YPbPr 1 or YPbPr 2. green blue red white red green blue red white red DVD or Set-top box DVD or Set-top box 15 Connecting the DVD player or HDTV Set-top box using HDMI input 1. Connect the PDP to the DVD player or HDTV Set-top box with the HDMI cable. Connect the DVI AUDIO input terminal to the audio output terminal of HDTV Set-top box with DVI output terminal, and a DVI to HDMI conversion cable should be adopted. Please ensure the Power Cord is connected and turned on the STANDBY button before it is operated. The second step is used, if you connect DVI output to the HDMI input of the PDP. The second step isn't used, if you connect HDMI output to the HDMI input of the PDP. HDMI don't support PC. DVI AUDIO HDMI red white DVD or Set-top box DVI DVD or Set-top box Connect audio amplifier or other TV set (Only for AV) 1. Connect audio amplifier apparatus or other TV set that with audio input. Connect the composite video output terminal to the video output terminal of the video input device. white red 16 Connecting the DVD, VCR or other video apparatus 1. S-VIDEO will connect only the video portion (image only) of the signal. With an AUDIO cable (RCA type) connect the AUDIO OUT from the device to the AUDIO IN on the PDP. With an AV cable connect to the Video plug of the PDP and the VCR or other video apparatus. With an AUDIO cable connect the audio output of the VIDEO of the VCR or other video apparatus to the audio input of the VIDEO of the PDP. Please ensure the Power Cord is connected and turn on Power Switch button before it is operated. To watch the VCR or other video apparatus, please press SOURCE button to select S-VIDEO or AV. white red red white VCR etc. VCR etc. 17 6. Basic Operation 6. 1 Power ON/OFF: The Display is in Standby mode - Press Standby ( ) button on the remote control or on the front panel to turn on the unit. - Press Standby ( ) button on the remote control or on the front panel again to return the display to standby mode. Note: For protecting your PDP product, the interval time between turn on the PDP product and shut down it should be kept at least one minute. 6. 2 Selection of Input Mode - Press Source button on the remote control or on the front panel. [. . . ] Such chemicals may damage the housing, screen glass and remote control, and cause the paint to peel. 2 Cleaning of Housing and Remote Control: - Use a soft cotton cloth for cleaning. - If the housing or remote control are seriously contaminated, use a soft cloth moistened with diluted neutral clean the Display. Wring water out of the cloth before cleaning to prevent water from penetrating into the housing. [. . . ]