User manual AIWA XR-MS3

[. . . ] 7 Condensation ­ Moisture may form on the CD pickup lens when: - The unit is moved from a cold spot to a warm spot - The heating system has just been turned on - The unit is used in a very humid room - The unit is cooled by an air conditioner When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again. 8 Wall or ceiling mounting ­ The unit should not be mounted on a wall or ceiling, unless specified in the Operating Instructions. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] The selected track starts to play and continues to the end of that disc. nOTE · The unit may not play a CD-R/RW disc that is recorded on personal computers or some kinds of CD-R/RW recorders because of differences in recording platforms. Do not attach any seal or label to either side (the recordable side or the labeled side) of a CD-R/RW disc. Number of track being played Elapsed playing time The display automatically changes to the level indicator after 4 seconds. Selected track number Program number To cancel random play, press RANDOM while pressing SHIFT so that "RANDOM" goes off. Total number of selected tracks Total playing time of the selected tracks A single track or all tracks can be played repeatedly. ""1" lights up when the single track repeat play is selected, and """ lights up when the all tracks repeat play is selected. Each time g is pressed in stop mode, a track number and program number will be displayed. To cancel repeat play, press REPEAT repeatedly while pressing SHIFT until """ and "1" disappear. To repeat random play First press RANDOM while pressing SHIFT to activate random play. Then press REPEAT while pressing SHIFT so that """ lights up. nOTE · During programmed play, you cannot select the tracks directly with the numbered buttons or perform random play. In the following cases, the total playing time of programmed tracks is displayed as "--:--", which means you cannot check the total playing time of programmed tracks, but the programmed tracks are still registered in memory. - the total playing time of programmed tracks exceeds 99 minutes and 59 seconds. When recording from a CD, CD play and tape recording start simultaneously. When recording from connected equipment, start play of the connected equipment. (Applicable when recording from a radio broadcast or connected equipment. 4-second blank spaces can be inserted at the desired point during recording. (Applicable when the source is a radio broadcast or connected equipment. ) 1 Press w REC/REC MUTE during recording or while in recording pause mode. To insert a blank space of less than 4 seconds, press w REC/REC MUTE again while 4 is flashing. To insert a blank space of more than 4 seconds, after the deck enters recording pause mode, press w REC/REC MUTE again. [. . . ] To clean the tape heads When the tape heads are dirty; - high frequency sound is not emitted - the sound is not adequately high - the sound is off-balance - the tape cannot be erased - the tape cannot be recorded on After every 10 hours of use, clean the tape heads with a head cleaning cassette. The power is not turned on © Disconnect the AC cord, and connect it again in a few seconds. this may narrow the output range of recorded tapes and increase noise. After 20 to 30 hours of use, demagnetize the heads with any commercially available demagnetizer. [. . . ]