User manual AIWA XR-EM20

[. . . ] CD Stereo System XR-EM20 U C Owner's record For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty. (Lot No. ) OPERATING INSTRUCTIONS En (English) MANUAL DE INSTRUCCIONES E (Español) MODE D'EMPLOI F (Français) For assistance and information (United States and Puerto Rico) 8C-CL7-903-01 011228ACK-H-BF WARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. IMPORTANT SAFETY INSTRUCTIONS Read the Operating Instructions carefully and completely before operating the unit. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below. [. . . ] Preset station numbers in the band which are higher than the cleared number decrease by one. 0­10, +10 s SET SHIFT PRESET +, TUNER/BAND f, g En f, g Manual tuning 1 Press TUNER/AUX/BAND (TUNER/BAND on the remote control) repeatedly to select a band. 2 Press f or g repeatedly to tune in a station. "TUNE" is displayed when a station is tuned in. ·Auto search may not stop at stations with weak signals. Preset tuning Preset up to 32 of your favourite stations and tune them in directly. Presetting stations 1 Tune in the desired station. 2 Press SET on the remote control to store the station. The preset number, beginning from "1" flashes on the display. 3 Repeat steps 1 and 2 to preset other stations. The next station will not be stored if a total of 32 preset stations have already been stored. ("FULL" is displayed. ) ·If power is interrupted for more than approximately 12 hours, all settings stored in memory after purchase need to be reset. 10 SOUND ADJUSTMENTS Adjustments To switch to monaural FM reception Hold down SHIFT and press TUNER MODE on the remote control so that "MONO" is displayed. To cancel, repeat the above so that "STEREO" is displayed. VOLUME TONE Tip: When FM stereo reception is poor, switching to monaural reduces noise. To switch the AM tuning interval The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval. Hold down TUNER/AUX/BAND and press POWER on the main unit. En VOLUME +, TONE Tip: When the AM tuning interval is changed, all preset stations are cleared. Volume Turn VOLUME (press VOLUME +, - on the remote control). Adjust from 0 (minimum) to 30 and MAX (maximum). Bass and treble 1 Press TONE repeatedly to display "BAS" or "TRE". "BAS" : Adjusts the bass level "TRE" : Adjusts the treble level Tip: Volume level setting is retained during power-off standby. If the unit is turned off with the volume set to 17 or higher, it is automatically turned down to 16 the next time the unit is turned on. 2 Within 6 seconds, turn VOLUME (press VOLUME +, - on the remote control). Each level can be adjusted from "­2" to "+5". ·If the sound becomes distorted, lower the level. 11 TAPE PLAYBACK Notes on cassettes TUNER MODE FUNCTION c REC/ REC PAUSE REC MUTE ·Use of 120-minute or longer tapes is not recommended since they are extremely thin and easily deformed or damaged. ·Wind up any slack in the tape with a pencil or similar tool before use. Slack tape may jam in the mechanism. En REC/ REC PAUSE SYNCHRO REC s s c f, g zPUSH EJECT f, g SHIFT Playback Use only type I (normal) tapes. 1 Press zPUSH EJECT to open the cassette holder. 2 Insert the tape. Insert with the exposed side down and the side to be played facing out from the unit, and press zPUSH EJECT to close the cassette holder. To stop playback Press s. To reset the tape counter Press s in stop mode, and the tape counter on the display is reset to "0000". Opening and closing the cassette holder will also reset the tape counter. To eject the tape Press zPUSH EJECT after the deck stops completely. 3 Press c to start play. 12 TAPE RECORDING Basic recording Use only type I (normal) tapes. 1 Press zPUSH EJECT to open the cassette holder. 2 Insert the recording tape. Insert with the exposed side down, and the side to be recorded on facing out from the unit. To start CD recording more easily Insert the tape to be recorded, load the disc, and press SYNCHRO REC. Regardless of the function currently selected, CD play and tape recording start simultaneously. ·In CD stop mode, tape recording starts from the beginning of the disc (all tracks recording). ·In CD playback mode, the unit returns to the beginning of the current track and it records only that track (one track recording). [. . . ] The unit shut off suddenly ·Possibly a short circuit in the speaker terminals. Disconnect the AC power cord from the AC outlet and reconnect the speaker cords correctly. (See "Resetting the unit" on this page. ) Poor radio reception ·Check antenna connection. ·Move the unit and antenna away from other electric appliances and cords. [. . . ]