User manual AIWA XD-DV270

[. . . ] DVD PLAYER CCC XD-DV270 OPERATING INSTRUCTIONS CCC En (English) CCC CCC 8A-AV5-902-01 010130AMK-Y-T HRJ HEJ ENGLISH WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. The CLASS 1 LASER PRODUCT label is located on the exterior. 4 Ventilation -- The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow a clearance of 10 cm from the rear and the top of the unit, and 5 cm from each side. - Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings. [. . . ] TV TYPE When your TV set is a conventional-screen size TV: ] [4:3 LB When your TV set is a wide-screen size TV: [16:9 ] NOTES · For the best possible picture clarity , it is recommended that an S (separate) video cord (not supplied) be used when connecting the unit to a TV set equipped with an Svideo input terminal. · When the picture noise appears while copy-protected DVDs are played, connect the unit directly to a TV set. Do not connect through a VCR, TV/VCR or AV selector . 16 ENGLISH REMOTE CONTROL Installing batteries Detach the battery cover on the rear of the remote control, and insert two R6 (size AA) batteries with 0 and 9 aligned correctly . ABOUT SYMBOLS PREPARATIONS Although this unit can play DVDs, super video CDs, V ideo CDs, Audio CDs or MP3 discs, some of the functions are restricted by the kinds of discs. In this operating instructions, the following symbols are used to make distinction. : Shows the function or the display for only DVDs. Shows the function or the display for only MP3 discs. : : When to replace the batteries The maximum operational distance between the remote control and the sensor of the units should be approximately 7 meters. : : NOTES · When operating with the remote control, point the top of the remote control toward the player . · If the unit is not going to be used for an extended period of time, remove the batteries to prevent possible electrolyte leakage. · The remote control may not operate correctly when: - The line of sight between the remote control and the unit is exposed to intense light, such as direct sunlight. - There is fluorescent lighting near the remote sensor in the display window . - Other remote controls are used nearby (those of a TV set, etc. ). No symbols: The function works in common. About the symbol display · The symbol will be displayed on TV screen if you press a button which cannot be used or enter an incorrect number. · Some discs may have places where they do not allow pressing of the STOP, SKIP, or other buttons. The mark will be displayed on the screen if you press a button that is not allowed in such a place. En ENGLISH 17 PLAYBACK Getting ready to play · Turn on the television, and set its video source (V ideo 1, Video 2, V ideo 3, etc. ) to the one connected to this unit. Set its input source to the one connected to this unit. 1 3 2, 4 c 1 2 Press POWER on this unit. On TV screen, "aiwa DVD VIDEO" screen is displayed. In the display window , "- on-" is displayed then it will change to "no disc". Press zOPEN/CLOSE. The disc tray opens. 2, 4 TOP MENU i/k/j/l/ENTER vRETURN MENU c 3 4 Load a disc. Place a disc in the tray guides (depression), with the label side facing up. When loading an 8-cm disc, place it in the inner depression. Press zOPEN/CLOSE. The disc tray closes, and the DVD player automatically begins to play the disc. If the disc does not begin to play , press c. POWER Audio TITLE KARAOKE CHP/TRK Video CD ANGLE PROG SHUF REP Audio TITLE KARAOKE CHP/TRK Video CD ANGLE PROG SHUF REP Audio TITLE KARAOKE CHP/TRK Video CD ANGLE PROG SHUF REP Audio TITLE KARAOKE CHP/TRK Video CD ANGLE PROG SHUF REP 18 ENGLISH When the menu screen is displayed The menu screen may be displayed first after loading a DVD, super video CD or video CD (version 2. 0) which contains a menu. Use ikjl to select the program you would like to view, then press ENTER to begin playback. Use the numbered buttons to select the program you would like to view. For either DVD, super video CDs or video CDs (version 2. 0), menu continuations and the exact operating procedures for using the menu may vary from disc to disc. Follow the instructions on the menu screen. Play Back Control (PBC) This unit equips Play Back Control (PBC) ON/OFF function. After turning off PBC, super video CDs or video CDs (version 2. 0) can be played back as well as audio CDs, without returning to the menu screen. 1 2 Press MENU once either while playing or when stopped. Within 2 seconds, press MENU again to turn off PBC. "PBC : [ON]" appears on TV screen. Moving the "aiwa DVD VIDEO" screen after 8 minutes To prevent TV screen from burning up, the "aiwa DVD VIDEO" screen moves around on TV screen, either when 8 minutes elapsed without any operations after the unit had stopped or when 8 minutes elapsed without any operations after playing an audio CD or MP3 disc. [. . . ] TAO (Track At Once) utility Data are written onto a disc track by track. Data can be added to a disc on which data were written with TAO utility. Packet writing utility Tracks are divided into smaller pieces while being recorded, depending on the size of available spaces on the disc. Data can be added to a disc on which data were written with packet writing utility. [. . . ]