User manual AIWA AZ-BS32

[. . . ] 4-254-827-11(1) The player USB Memory Player with FM Radio Operating Instructions AZ-BS1/BS32 ©2004 Sony Corporation WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire, do not cover the ventilation of the apparatus with news papers, table cloths, curtains, etc. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. Certain countries may regulate disposal of the battery used to power this product. [. . . ] *4 Press and hold Nx/POWER. *1 Each time you press the button, playback proceeds to the next or previous track. *2 When the first track is reached, playback of the first track starts. *2 Playback stops when all the tracks in the "pavit" have been played. To return to normal play mode Set the PLAY MODE switch to NORM. 14 B Listening to the radio PRESET TUNER Nx/POWER . (DOWN)/>(UP) Listening to the radio You can listen to FM broadcasts with and without inserting the "pavit" in the player. 3 1 Press and hold Nx/POWER until the player is turned on. If the radio was selected when you turned off the player last time, or if the "pavit" is not inserted in the player, the radio will be selected automatically when you turn on the player. Press TUNER repeatedly to select "FM 1" or "FM 2. " Press and hold . The player starts scanning the frequencies and stops when it finds a receivable station. (DOWN) or > (UP) repeatedly, the frequency changes step by step. Using the radio 2 To turn off the radio Turn off the power by holding down Nx/ POWER until "SEE YOU" appears in the display. If you press Nx/POWER when the "pavit" is inserted in the player, music data will be played from the position where the playback was last stopped. When the "pavit" is not inserted in the player, radio reception will continue if you press Nx/POWER. (Continued) 15 To enhance detection of receivable stations If there are stations that you want preset but cannot do it automatically because their signals are not strong enough, change the setting of "AUTO STOP LEVEL" to "HIGH" in order to enhance detection of receivable stations. (DOWN) or > (UP) repeatedly to select "AUTO STOP LEVEL. " 3 Press MENU. (DOWN) or > (UP) to select "HIGH*. " In case the same station is preset on two or more preset numbers because its signal is too strong, set the "AUTO STOP LEVEL" to "LOW. " 5 Press MENU. * The default setting at the time of purchase is "MID. " To improve the reception The player's handle functions as the FM antenna. Change the position of the handle or the player itself to improve the reception. You can use the supplied FM wire antenna to gain extra sensitivity. Attach the FM wire antenna by screwing it into the EXT ANT socket on the rear side of the player as shown below. Then, extend and position the FM wire antenna for the best reception. Note Changing the setting of "AUTO STOP LEVEL" does not change the reception sensitivity. 16 Presetting radio stations You can preset up to 20 FM radio stations, 10 stations each for FM 1 and FM 2. To preset a station manually (Manual preset) If there is a station that cannot be preset automatically, you can preset it manually by the following procedure. Before starting, you must exit the auto preset mode (" " and the preset numbers should not be displayed). 1 Press TUNER repeatedly to select "FM 1" or "FM 2. " 2 Tune in the station you want to preset. or > repeatedly to select the preset number you want to store the station on. 5 Within 10 seconds, press PRESET. To preset stations automatically (Auto preset) 1 2 3 Perform steps 1 and 2 of "Listening to the radio" (page 15) to select the band. " " starts flashing, and the player starts scanning for stations from the lower frequencies. Using the radio To tune in a preset station 1 2 The first received station is preset on the preset number 1, and then the player starts scanning for the next receivable station. Press TUNER repeatedly to select "FM 1" or "FM 2. " Press PRESET to display the preset numbers. or > repeatedly to select the preset number of the station you want to tune in. 3 If you press Nx/POWER or TUNER during auto presetting, the player stops scanning and exits the auto preset mode, and music data playback starts or the radio is switched to the other band. To clear all preset stations Turn off the power, remove the "pavit" from the player, and press and hold Nx/POWER for more than 10 seconds. The preset stations return to those at the time of purchase. 17 B Available features Using the stopwatch You can use the player as a stopwatch. The stopwatch has a lap time feature enabling you to calculate a gap from a previous stored time. [. . . ] In such a case, we will repair the product at your expense. If you have any questions or problems concerning your player, please consult your nearest Aiwa dealer. 22 Troubleshooting If you experience any of the following difficulties while using your player, use this troubleshooting guide to help you to remedy the problem. For trouble concerning operations while connected to your computer, also refer to "Troubleshooting" in the separate manual "Music Transfer pavit Edition. " Operation Symptom There is no sound. Reinsert the "pavit" and check if the "pavit" insertion indicator " " is displayed (page 10). Send MP3 files encoded with higher bit rates to the "pavit. " c The batteries are exhausted. [. . . ]