User manual AIWA AM F-65

[. . . ] OWNER'S RECORD For your convenience, record the model number and serial number (you will find it in the disc holder) in the space provided below. Please refer tothem when you contact your Aiwa dealer in case of difficulty. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Parl 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation, This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] You can adjust the recording level during analog recording and microphone recording. To record the sound source better, adjust the recording level referring to page 30. Tip record on a previously recorded disc If there is an unrecorded section left on the disc, the new recording automatically starts from where the previous recording finished. If there is not enough unrecorded section left, or you want to record after erasing previous recordings, erase the recording referring to page 62. TO protect the recorded contents + @ TO record + @ If recording or editing is attempted when the tab is set to the protect position, "F)ROTECTED appears and the operations are deactivated. 4 Press + or - referring to the level meter in the display to adjust the recording level . Set the recording level @ as high as possible but not reaching the OVER indication. Press MODE while in recording pause mode to display "MANUAL", then press ENTER to display "A. To search for a desired passage quickly, you can register up to 254 index marks. During digital recording from a CD or MD+~ The index mark information recorded on the CD or MD is copied as it is. @)CD or MD @ Recording (MD) @ Index marks During analog recording microphone recording + If there is an unrecorded longer than 3 seconds, an be registered automatically is input next time. @) Input sound @ Recording (MD) @ While there is no sound @ Index marks or You can register an index mark by pressing ~ during recording even if the Marker function is set to OFF. This function is activated when the Auto marker or Time marker function is set. note The index mark may not be registered correctly even if the Auto marker function is set. Q You cannot register index marks without registering the track number. S You cannot register anyindexmark ona disc with 254 tracks already recorded. @Auto marker function @Time marker function @ Marker function off 3 Press El I to start recording, Note Selected marker function is retained after the power is turned off. The available time printed on the disc can be doubled when the sound is recorded in monaural. Note c Every time you change the recording mode, the track number advances by one. Q While recording a stereo sound source in monaural, thesoundfrom the headphones will be heard in stereo. Q A disc recorded in monaural cannot be played back on another MD player which cannot play backa monaural recorded disc. Recording pauses when there is no sound, and resumes automatically when the sound begins again. [. . . ] Therefore, the quality of recorded sound does not deteriorate even after many playbacks and recordings. A newly developed digital audio compression technology called the ATRAC system automatically extracts only the frequencies that are actually audible to the human ear and cuts the frequencies which are inaudible. this compresses the amount of information to be recorded to 1/5 of the normal amount. The ATRAC system is based upon studies carried out in the field of auditory psychology and does not impair the quality of the audible sound. [. . . ]