User manual AIRLIVE WL5460AP

[. . . ] 0 The default SSID is airlive The default Channel is 11 The default DHCP client is Disabled The default is set to AP mode This Wireless Access Point can support four modes AP, Client, Bridge, Repeater (WDS) If you want to change to Repeater mode, please go to Status> WDS Setting to enable the WDS function Under Bridge Mode, you can set WEP Key or WPA in order to prevent unrelated people to eavesdrop. [. . . ] Turns solid green when connected and associated to at least a client station. Please install your network cards first before the AP Screw-in the antenna (clockwise) into the Antenna connector Connect the power and LAN cable to the back Use your wireless card to do a site survey, the default SSID is airlive and Channel is 11 If you need to change AP's configuration, please follow the procedure below: The AP's default IP address is 192. Any parameter change will cause the device to reboot for the new settings to take effect. Mode: This Wireless Access Point can support three modes AP, Client, and Bridge. Network Type: When in Client mode, you can select between Ad-Hoc and Infrastructure. Wireless: WDS Setting In order to set "WDS", you need to check on the WDS Setting Please make sure both A and B are set to the same ESSID and channel Bridge Mode Device A: Mode: Client Network Type: Ad-Hoc Device B: Mode: Client Network Type: Ad-Hoc Please make sure both A and B are set to the same ESSID and channel To enhance security, you can disable the "Broadcast SSID" function under "Wireless->Advance Settings". [. . . ] Please make sure both A and B are set to the same ESSID and channel OvisLink Corporation declares that this device is in compliance with the essential requirements and other relevant provisions of directive 1999/5/EC [. . . ]