User manual AGFAPHOTO DC-733I

[. . . ] Please read these operating instructions carefully in order to use the product correctly. Keep the instructions in a safe place after reading so that you can refer to them later. Disclaimer We assume no responsibility over and above the provisions of the Product Liability Law for damages suffered by the user or third parties as a result of inappropriate handling of the product or its accessories, or by their operational failure and by their use. We reserve the right to make changes to this product and its accessories without prior notice. [. . . ] In macro mode you can focus on subjects 15 cm from the lens when in the maximum wide angle (zoomed out) setting and 40 cm in the maximum telephoto (zoomed in) setting. 1 2 Turn the power on, and set the camera to the REC mode ( page 13). Press the macro button ( ) enters the macro mode. To leave the macro mode, press the macro button ( ) again. 3 Press shutter button to take a picture. Tips Distances referred to measure the distance between the camera lens surface and the subject. 24 Using the Self-timer & Burst Use the self-timer to set a delay from the time the shutter button is pressed to the time the image is shot. Use the burst to record continuous still images shooting. 1 2 3 Turn the power on, and set the camera to the REC mode ( page 13). Press Off: or to select [Drive mode] to select a drive mode, then press the SET button. Double: Record two images in a shot after pressing the shutter release button 10 and 12 seconds. Burst: Keep pressing the shutter button fully to take a continuous shooting. Release the shutter button to stop shooting. 4 Press shutter button to take a picture. Tips When using the self-timer function, be sure to use a tripod or place the digital camera on a level, stable surface. 25 Recording Movie Clips 1 2 Turn the power on, and set the camera to the Movie mode ( page 13). Compose the subject on the monitor. The LCD monitor displays the available recording time ( ). 3 Start recording. The White Balance is set and locked to the settings of the first frame Caution Sound cannot be recorded while pressing the zoom button. The digital zoom cannot be used in Movie mode. 4 Finish recording. The camera will stop recording automatically when the memory capacity has been reached. Setting the Movie Size Movie Size and Frame Rate Resolution 640 x 480 320 x 240 160 x 120 30 frames/sec. Lower Quality Frame Rate Higher Quality 26 Recording Audio Clips 1 2 Turn the power on, and set the camera to the Voice REC mode ( page 13). Press the shutter button ( ) to start recording. Be careful to avoid touching the microphone while recording 3 Press the shutter button again to end recording. The camera will stop recording automatically when the memory capacity has been reached. Playing Back Audio Clips 1 2 3 Turn the power on, and set the camera to the PLAY mode ( page 13). Press or to select the audio clip that you want to playback. Start playing back. When audio clip paused, press 27 Recording a Voice Memo You can add a voice memo to the still images after you record it. 1 2 Turn the power on, and set the camera to the PLAY mode ( Press or page 13). to select a still image that you want to add a voice memo. If the image already has the voice memo recorded, the icon appears on the LCD monitor. The new recording will replace the previous one. 3 4 Open the PLAY menu. Press the MENU button, using four-way control to select Voice Memo ( ) and press the SET button. Press the SET button to start recording for 30 seconds. Press the SET button again to end recording. Caution The voice memo cannot be added to a movie clip or a protected image. When you delete the image, the attached voice memo is also deleted. Playing Back a Voice Memo 1 2 3 Turn the power on, and set the camera to the PLAY mode ( page 13). Press or to select the image that has the voice memo recorded. Start playing back. When voice memo paused, press 28 Other Recording Functions Setting the Metering There are 3 different light metering options available on your camera. Option Description Light is measured from the entire shooting screen, but gives more importance to the values near the center. [. . . ] Ulead VideoStudio features an intuitive step-based interface that helps you get started right away. After finishing a project, share your videos through e-mail or on the Web, or bum your own high-quality VCDs, SVCDs and DVDs. To start the program, click Start > Programs >Ulead VideoStudio7 > Ulead VideoStudio 7 SE VCD. 48 Appendix About the Folder & File Name Your digital camera automatically creates a directory of folders in the internal memory or memory card that it uses to organize still images, movie clips and other information. Folder Structure Folder name begins with a 3-digit number from 100 to 999 and followed by "DICAM", each folder holds up to 9999 files. [. . . ]