User manual AEG SMT 355

[. . . ] The wheel may bind, walk up or kickback if the power tool is restarted in the workpiece. The motor's fan will draw the dust inside the housing and excessive accumulation of powdered metal may cause electrical hazards. SPECIFIED CONDITIONS OF USE The Cutting-off Grinder is to be used for cutting metal sections, metal pipes and metal bars into lengths. [. . . ] Do not dispose of electric tools together with household waste material!In observance of European Directive 2002/96/ EC on waste electrical and electronic equipment and its implementation in accordance with national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. Read all safety warnings and all instructions, including those given in the accompanying brochure. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Appliances used at many different locations including open air should be connected via a residual current device of 30 mA or less. Always disconnect the plug from the socket before carrying out any work on the machine. The use of protective clothing is recommended, such as dust mask, protective gloves, sturdy non-slip footwear, helmet and ear defenders. Sawdust and splinters must not be removed while the machine is running. Never use the Cutting-Off Grinder to cut materials other than those specified in the instruction manual. The handle lock must always be engaged when transporting the Cutting-Off Grinder. Only use the Cutting-Off Grinder with guards in good working order and properly maintained, and in position. The adjusting nut must be tightened before starting to work with the machine. Do not use cut-off wheels which are damaged or deformed Always use and store the cut-off wheels according to the manufacturer`s instructions. Use only cut-off wheels that are recommended for your power tool and the specific guard. Cut-off Wheels for which the power tool was not designed cannot be adequately guarded and are unsafe. The guard must be securely attached to the power tool and positioned for maximum safety, so the least amount of cut-off wheel is exposed towards the operator. [. . . ] Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden, Germany. NÄTANSLUTNING Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]