User manual AEG FFB52600ZW

[. . . ] We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler ­ features you might not find on ordinary appliances. visit our website to: Get usage advice, brochures, trouble shooter, service and repair information: www. Buy Accessories, Consumables and Original spare parts for your appliance: www. When contacting our Authorised Service Centre, ensure that you have the following data available: Model, PNC, Serial Number. [. . . ] Each performed softener rinse (possible more than one in the same cycle) may prolong the programme duration by another 5 minutes when it occurs at any point at the beginning or in the middle of a programme. All the consumption values mentioned in this section are determined in accordance with the currently applicable standard in laboratory conditions with water hardness 2. 5mmol/L according to the 2019/2022 regulation (water softener: level 3). The pressure and the temperature of water as well as the variations of the mains supply can change the values. How to set the water softener level Make sure the appliance is in user mode. The display shows the current Press the on/off button to confirm the The rinse aid helps to dry the dishes without streaks and stains. When rinse aid chamber is empty, the rinse aid indicator is turned on notifying to refill rinse aid. If the drying results are satisfactory while using multi-tablets only, it is possible to deactivate the notification for refilling rinse aid. If standard detergent or multi-tablets without rinse aid are used, activate the notification to keep the rinse aid refill indicator active. The salt is used to recharge the resin in the water softener and to assure good washing results in daily use. The washing results are the same as with the normal programme duration. Press Option until the indicator The display shows the updated programme duration. Carefully shake the funnel by its handle to get the last granules inside. Turn the cap of the salt container clockwise to close the salt container. After you fill the salt container, immediately start a programme to prevent corrosion. Fill the dispenser (A) until the rinse aid reaches the marking ''MAX''. Remove the spilled rinse aid with an absorbent cloth to prevent excessive foam formation. You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 or 6 (highest quantity). If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. This function decreases energy consumption by deactivating automatically the appliance when it is not operating. The function comes into operation: · Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode and the door is closed. [. . . ] Refer to "Before first use", "Daily use", or "Hints and tips" for other possible causes. Once you have checked the appliance, deactivate and activate the appliance. For alarm codes not described in the table, contact an Authorised Service Centre. We do not recommend using the appliance until the problem has been completely fixed. [. . . ]