User manual AEG FEE53610ZM

[. . . ] We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler ­ features you might not find on ordinary appliances. visit our website to: Get usage advice, brochures, trouble shooter, service and repair information: www. Buy Accessories, Consumables and Original spare parts for your appliance: www. When contacting our Authorised Service Centre, ensure that you have the following data available: Model, PNC, Serial Number. [. . . ] This process is automatic and is the part of the normal dishwasher operation. When the prescribed quantity of water (see values in the table) has been used since the previous regeneration process, A new regeneration process will be initiated between the final rinse and the programme end. In case of the high water softener setting, it may occur also in the middle of the programme, before the rinse (twice during a programme). In such cases, the regeneration prolongs the total duration of a programme by additional 5 minutes. Subsequently, the rinsing of the water softener that lasts 5 minutes may begin in the same cycle or at the beginning of the next programme. Each performed softener rinse (possible more than one in the same cycle) may prolong the programme duration by another 5 minutes when it occurs at any point at the beginning or in the middle of a programme. All the consumption values mentioned in this section are determined in line with the currently applicable standard in laboratory conditions with water hardness 2. 5mmol/L (water softener: level 3) according to the regulation: 2019/2022 . The pressure and the temperature of water as well as the variations of the mains supply can change the values. After starting the programme, the appliance recharges the resin in the water softener for up to 5 minutes. The salt is used to recharge the resin in the water softener and to assure good washing results in daily use. Carefully shake the funnel by its handle to get the last granules inside. Fill the dispenser (A) until the rinse aid reaches the marking ''MAX''. Remove the spilled rinse aid with an absorbent cloth to prevent excessive foam formation. You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 or 6 (highest quantity). Turn the cap of the salt container clockwise to close the salt container. After you fill the salt container, immediately start a programme to prevent corrosion. If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. For information about the detergent dosage, refer to the manufacturer's instructions on the packaging of the product. Usually, 20 - 25 ml of gel detergent is adequate for washing a load with normal soil. Do not fill the compartment (A) with more than 30 ml of gel detergent. This function decreases energy consumption by deactivating automatically the appliance when it is not operating. [. . . ] Refer to "Before first use", "Daily use", or "Hints and tips" for other possible causes. Once you have checked the appliance, deactivate and activate the appliance. For alarm codes not described in the table, contact an Authorised Service Centre. We do not recommend using the appliance until the problem has been completely fixed. [. . . ]