User manual AEG-ELECTROLUX ZE360WP

[. . . ] Please remove the plug from the socket outlet before cleaning or maintaining the appliance. Never use the vacuum cleaner: · · · · · · In wet areas. On fine dust, for instance from plaster, concrete, flour, hot or cold ashes. Using the vacuum cleaner in the above circumstances may cause serious damage to its motor. Never use the vacuum cleaner without its filters. Electrical cable precautions · A damaged cable should only be replaced by an authorised Electrolux service centre. [. . . ] * On the Dust Magnet nozzle (23 and 24) there is normally no need to switch mode. It can be used with brush up on all surfaces for maximal convenience with maintained excellent dust removal result. The brush setting should be used to reach optimal dust removal even on difficult hard floors or to get a combing effect on carpets. Hard floors: * Use the carpet/hard floor nozzle with lever in position (22). Upholstery: Curtains, lightweight fabrics etc. : Use the upholstery function of the 3 in 1 multi tool nozzle (5a). Frames, bookshelves, etc. : Use the dusting brush function of the 3 in 1 multi tool nozzle (5b). Crevices, corners, etc. : Use the crevice function of 3 in 1 multi tool nozzle (5c). * Using the turbo nozzle (7) Note: Do not use the turbo nozzle on skin rugs, rugs with long fringes or a pile depth exceeding 15 mm. To avoid damaging the carpet, do not keep the nozzle stationary whilst the brush is rotating. Do not pass the nozzle across electric cables, and be sure to switch off the vacuum cleaner immediately after use. 25 The dust bag must be replaced latest when the indicator window is completely red. Read with the nozzle lifted up. * Certain models only. 9 2193584-02Outline. indd 9 10/17/08 1:58:23 PM 26 29 27 28 30 31 32 33 34 10 2193584-02Outline. indd 10 10/17/08 1:58:24 PM English Replacing the dust bag, s-bag® 26 27 Open the front cover and lift out the insert holding the s-bag®. This automatically seals the s-bag® and prevents dust leaking out. Insert a new s-bag® by pushing the cardboard right into the end of the groove in the insert. Put the insert back into the bag compartment, and close the cover. 28 29 Note. [. . . ] Use the hose handle to clean the nozzle. Cleaning the turbo nozzle* 38 * Certain models only. 13 2193584-02Outline. indd 13 10/17/08 1:58:25 PM 14 2193584-02Outline. indd 14 10/17/08 1:58:26 PM English Troubleshooting The vacuum cleaner does not start · Check that the cable is connected to the mains. · Check for a blown fuse. The vacuum cleaner stops · Check whether the dust bag, s-bag® is full. · Are the filters blocked? Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorised Electrolux service centre. [. . . ]