User manual AEG-ELECTROLUX Z8215

[. . . ] 1 Adjust the suction power by pressing the Max-Min button on the vacuum cleaner or by pressing either the Max or Min button on the remote control. The light for suction power turns dark blue at max suction power and light blue at min suction power. And Max In motorised floor nozzles () detect the type of surface being vacuumed. Max In, Max In Turbo and Max In motorised floor nozzles, are ideal for both hard floors and carpets. [. . . ] The Max In motorized nozzle receives power via the tube and hose, and no additional electrical connections are needed. a blue light on the nozzle indicates that the brush roller is turning. If anything should become lodged in the brush roller, the light turns off. Note: Do not use the Max In Turbo or Max In motorised nozzles on fur rugs, rugs with long fringes or pile depths exceeding 15 mm. To avoid damaging the carpet, do not let the nozzle stay in one place when the brush is rotating. Do not pass the nozzle over electrical cords, and be sure to switch off the vacuum cleaner immediately after use. 19 When you pause during cleaning, the tube can be attached to the rear of the vacuum cleaner. 0 When storing, the vacuum cleaner can be placed on end and the tube attached at the bottom of the vacuum cleaner. Soulever le support de filtres et le faire pivoter d'un demi-tour pour échanger les filtres, puis remettre en place le support de filtres dans l'aspirateur. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. If something gets stuck in the vacuum cleaner: Turn off the vacuum cleaner and open the cover at the front of the unit by lifting the release catch. 8 Lift the cover between the filter wells and remove anything that may have got stuck. Put the filter holder back in place and close the vacuum cleaner cover. If something gets stuck in the vacuum cleaner 0 The Max In and the carpet/floor nozzles should be cleaned frequently to avoid losing suction power. Always unplug the vacuum cleaner from the wall outlet before cleaning. To remove the brush roller cover, push the outer latch out, and the middle cover to the left, and this will also free the wheels for cleaning. 8 Remove the cover on the side of the round space by pulling it straight out. [. . . ] 8 Remove the cover on the side of the round space by pulling it straight out. If you use water, make sure that the cartridge is dry before you put it back. If so, empty it and clean both the box and the filter before putting it back in the cleaner. Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. [. . . ]