User manual AEG-ELECTROLUX WTSL4E200

[. . . ] Safety information Environment concerns Technical information Product description Control panel Programmes Consumption values Before first use Using the appliance - Washing only Loading the laundry 2 4 5 5 6 10 14 14 14 14 Filling the detergent and additives Setting and starting a programme At the end of the programme Using the appliance - Drying only Using the appliance - Washing & Drying 15 16 17 17 Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge use the appliance. They must have supervision or instruction for the operation of the appliance by a person who is responsible for their safety. [. . . ] Wash Rinses Short spin One rinse with additive spin phase Drainage of the water Spin phase 40° Complete programme composed of washing phase + drying phase for a small load size mixed fabrics (cotton and synthetic items). Set this programme to have a good washing results and decrease the energy consumption. 2) The Stain function is not available with a temperature lower than 40°C. Store dry For items to put away Iron dry For ironing Degree of drying Type of fabric Load (Kg) 7 Extra dry For towelling materials Cotton and linen (bathrobes, bath towels, etc) 5 2 Cupboard dry1) For items to put away Cupboard dry For items to put away 7 Cotton and linen (bathrobes, bath towels, etc) Synthetics and mixed fabrics (jumpers, blouses, underwear, household linen) Cotton and linen (sheets, tablecloths, shirts, etc. ) Wool (jumpers) 5 2 3 1 7 Iron dry Suitable for ironing Wool dry 5 2 1 Spin speed (rpm) 1600 1600 1600 1600 1600 1600 1200 1200 1600 1600 1600 1200 Suggested times (mins) 240 - 250 140 - 160 85 - 95 230 - 240 130 - 150 75 - 85 135 - 145 40 - 50 210 - 230 100 - 120 65 - 75 110 - 130 1) Hints for test institute The test performance, in accordance with EN 50229, must be carried out with the a FIRST drying load of 6 kg (load composition : pillowcase and towels) by setting the AUTOMATIC CUPBOARD DRY programme for Cotton. The SECOND drying load of 3 kg (load composition: 3 sheets and towels) must be tested by setting the AUTOMATIC CUPBOARD DRY programme for Cotton. 1) «Cotton Energy Saving programme » at 60°C with a load of 9 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards. The consumption data shown on this chart is to be considered purely indicative, as it may vary depending on the To activate the drain system, put 2 litre of water in the main wash compartment of the detergent dispenser. Put a small quantity of detergent in the main wash compartment of the detergent dispenser. set and start a programme for cotton at the highest temperature without laundry. If you use a liquid detergent, put it immediately before you start the programme. Flap for powder or liquid detergent Turn it (up or down) in the correct position to use powder or liquid detergent. Always obey the instructions that you find on the packaging of the detergent products. With the flap in the position DOWN: ­ Do not use gelatinous or thick liquid detergents. ­ Do not put more liquid detergent than the limit showed in the flap. Make sure that the flap does not cause a blockage when you close the drawer. The display shows the default temperature, the spin speed and the empty indicator bars of the available functions. The drain pump can operate for a short time when the appliance fills water. The appliance adjust automatically the cycle time to the laundry you have put in the drum to have perfect washing results in the minimum necessary time. After approximately 15 minutes from the start of the programme, the display shows the new time value. CHANGE A FUNCTION You can change only some functions before they operate. Press button 7 again and again until the display shows the number of minutes or hours. [. . . ] Put 2 litres of water in the main wash compartment of the detergent dispenser. FROST PRECAUTIONS If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump. Put the two ends of the inlet hose in a container and let the water flow out of the hose. Make sure that the temperature is more than 0 °C before you use the appliance again. [. . . ]