User manual AEG-ELECTROLUX TW SL6E 102

[. . . ] This appliance is not intended for use by persons (including children) with reduced physical and sensory conditions or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. ⷠMake sure that small children and pets do not climb inside the drum. Please make sure that no gas lighters or matches have accidentally been left in pockets of garments incase they are loaded into appliance Avertissement · risk of fire!Never stop a tumble dry before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. [. . . ] Do not restrict the floor clearance through deeply carpets, strips of wood or similar. This might cause heat built-up which would interfere with the operation of the appliance. The appliance must therefore not be installed on floors which are not resistant to high temperatures. When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. The appliance must not be installed behind the lockable door, a sliding door or a door with a hinge on the opposite side to that of the appliance. Before appliance use all packaging parts and drying rack must be removed from the drum. Electrical connection Details on mains voltage, type of current and the fuses required should be taken from the type plate. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Center. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the machine and screw down. Note regarding contact protection: The machine is only secure for operations again once all plastic parts have been inserted. special accessories · Stacking kit These intermediate installation kits can be used to arrange the dryer and a washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. Available from your Service Force Centre or your specialist dealer · draining kit Installation kit for direct draining of the condensed water into a basin , siphon , gully , etc. The water reservoir then no longer has to be drained, it must however remain in its intended position in the machine. Fixed hose has to be on the suitable height from minimum of 50 cm to maximum of 1 m from floor level and cannot be looped. Available from your Service Force Centre or your specialist dealer · Pedestal with the drawer To situate the dryer at the optimal height and have some additional space to store (e. Available from your Service Force Centre or your specialist dealer Unscrew hinge A from the front of the machine and take off the loading door. To do this, insert a thin screwdriver into the slots as shown in the illustration, press downwards slightly and pry out the cover plates. Use an appropriate tool and exert pressure to unfasten locking block C from the snap-on fixture, take out and re-insert on the other side having rotated the block through 180°. Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down. All without Time (Zeiwahl) all without Time (Zeiwahl) all without Time (Zeiwahl) To dry laundry with the time set by the user. [. . . ] To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. Never operate the dryer without fluff filters or with damaged or blocked fluff filters. A dirty heat pump can only be cleaned up by means of a costly process. Once every 6 months, remove the fluff from the heat exchanger using the sponge supplied. [. . . ]