User manual AEG-ELECTROLUX TR ETN1223H UKOK

[. . . ] Types of salt that are not specified for dishwashers can cause damage to the water softener. ⷠFill the appliance with salt before you start a washing programme. Remaining salt in the appliance can cause corrosion or make a hole in the bottom of the appliance. Do not fill the rinse aid dispenser with other products than the rinse aid, (dishwasher cleaning agent, liquid detergent). [. . . ] Make sure not to squash or cause damage to the mains plug and cable behind the appliance. ⷠMake sure that there is access to the mains plug after the installation. Internal lamp This appliance has an internal lamp that comes on when you open the door and goes off when the door is closed. Disconnect the mains plug from the mains socket before the replacement of the internal lamp. to discard the appliance · To prevent the risk of injury or damage: ­ Disconnect the mains plug from the mains socket. ⷠIf an accident occurs with these detergents, contact immediately a physician. ⷠIf the detergent gets into the mouth, contact immediately a physician. ⷠIf the detergent gets into the eyes, contact immediately a physician and clean the eyes with water. ⷠKeep dishwasher detergents in a safe area and out of children touch. ⷠDo not keep the appliance door open when there is detergent in the detergent dispenser. ⷠFill the detergent dispenser only before you start a washing programme. Use of rinse aid Rinse aid makes it possible to dry the dishes without streaks and stains. Use of detergent To help the environment, do not use more than the correct quantity of detergent. If the washing programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. If you use the detergent tablets, put the tablet in the detergent dispenser 1 . Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. You can set the rinse aid dosage between position 1 (lowest dosage) and position 4 (highest dosage). Be sure that these tablets are applicable for the water hardness in your area (refer to the instructions on the packaging of the products). activate or deactivate the multitab function before the start of a washing programme. You cannot activate or deactivate the function when a washing programme operates. ­ When you activate the multitab function, it stays on until you deactivate it. When the washing programme is completed, adjust the water softener to the water hardness in your area. [. . . ] ⷠPress the Reset button until the display shows two horizontal status bars. Make sure that there is detergent in the detergent dispenser before you start a new washing programme. For better drying results, keep the appliance door ajar for some minutes. remove the items from the baskets · Let the dishes become cold before you remove them from the appliance. [. . . ]