User manual AEG-ELECTROLUX TR ETN1221V SCA

[. . . ] Types of salt that are not specified for dishwashers can cause damage to the water softener. ⷠFill the appliance with salt before you start a washing programme. Remaining salt in the appliance can cause corrosion or make a hole in the bottom of the appliance. ⷠDo not fill the rinse aid dispenser with other products than the rinse aid, (dish- Make sure that the spray arms can move freely before you start a washing programme. [. . . ] Make sure that the electrical information on the rating plate agrees with the power supply. Make sure not to squash or cause damage to the mains plug and cable behind the appliance. ⷠMake sure that there is access to the mains plug after the installation. to discard the appliance · To prevent the risk of injury or damage: ­ Disconnect the mains plug from the mains socket. ⷠIf an accident occurs with these detergents, contact immediately a physician. ⷠIf the detergent gets into the mouth, contact immediately a physician. ⷠIf the detergent gets into the eyes, contact immediately a physician and clean the eyes with water. ⷠKeep dishwasher detergents in a safe area and out of children touch. ⷠDo not keep the appliance door open when there is detergent in the detergent dispenser. ⷠFill the detergent dispenser only before you start a washing programme. When the washing programme starts, a red visual signal shows on the floor below the appliance door. Use of rinse aid Rinse aid makes it possible to dry the dishes without streaks and stains. the rinse aid dispenser automatically adds rinse aid during the last rinsing phase. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. You can set the rinse aid dosage between position 1 (lowest dosage) and position 4 (highest dosage). Be sure that these tablets are applicable for the water hardness in your area (refer to the instructions on the packaging of the products). activate or deactivate the multitab function before the start of a washing programme. You cannot activate or deactivate the function when a washing programme operates. Press and hold function buttons (D) and (E) at the same time until the multitab indicator comes on. When you activate the multitab function, it stays on until you deactivate it. Press and hold at the same time, function buttons (D) and (E) until the multitab indicator goes on. When the washing programme is completed, adjust the water softener to the water hardness in your area. [. . . ] For better drying results, keep the appliance door ajar for some minutes. remove the items from the baskets · Let the dishes become cold before you remove them from the appliance. ⷠFirst remove the items from the lower basket, then from the upper basket. This prevents the remaining food to bond on the dishes and bad odours to come out from the appliance. [. . . ]