User manual AEG-ELECTROLUX T71270AC

[. . . ] Operating Instructions Important safety information Environment Installation Appliance positioning Removing transport safety packaging Electrical connection Changing door stop Special accessories Product description Control panel Control panel Display Before first use Programme overview Daily use Sorting laundry Average laundry weights Switching machine/drum light on Laundry loading Selecting the programme 76 76 78 79 79 79 80 80 81 82 83 83 83 84 84 85 85 86 86 87 87 DELICATE (SCHON) function 87 LONG ANTI-CREASE (KNITTERSCHUTZ PLUS) function 87 BUZZER (SIGNAL) function 88 TIME (ZEITWAHL) function 88 DELAY START (ZEITVORWAHL) 88 Child lock 88 Starting the programme 89 Changing programme 89 Drying cycle complete / removing laundry 89 Care and cleaning 90 Cleaning fluff filter 90 Cleaning the door seal 91 Emptying the condensate tank 91 Cleaning heat exchanger 92 Cleaning the drum 93 Clean operating screen and housing 93 What to do if . 94 Machine settings 95 Technical data Service 96 97 Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] The appliance must therefore not be installed on floors which are not resistant to high temperatures. When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. The appliance must not be installed behind a lockable door, a sliding door a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the dryer is restricted. Details on mains voltage, type of current and the fuses required should be taken from the type plate. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Center. A B Unscrew hinge A from the front of the machine and take off the loading door. To do this, insert B A a thin screwdriver into the slots as shown in the illustration, press downwards slightly and pry out the cover plates. Use an appropriate tool and exert pressure to unfasten locking block C from the snapon fixture, take out and re-insert on the other side having rotated the block through 180°. Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down. Re-insert cover plates B on the opposite site having first rotated them through 180°. If the display is showing 20h and you press the button again, the time delay will be cancelled. The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. The child lock can be activated or deactivated by holding down the BUZZER (SIGNAL) (3) and TIME (ZEITWAHL) (4) buttons simultaneously for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed The icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF (AUS) and then reset the programme. The programme can no longer be changed directly once the programme has started. The drying programme is not however affected by this (laundry protection). If the BUZZER (SIGNAL) button has been pressed, an acoustic signal sounds intermittently for about one minute. The drying cycles are automatically followed by an anti-crease phase which lasts around 30 minutes. [. . . ] Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. Vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. [. . . ]