User manual AEG-ELECTROLUX T57802

[. . . ] Tips and information about the economical and environmentally friendly use of the machine are marked with the clover symbol. If you require assistance or advice on your appliance, please contact our Customer Care Department by letter or telephone: Customer Care Department AEG Domestic Appliances 55-77 High Street Slough Berkshire SL 1 1DZ Tel: 08705 350350 3 2 Printed on environmentally friendly paper . . . 39 4 1 Important Safety Information Your safety is of paramount importance, please ensure you read these warnings before installing or using the appliance. If you are unsure about any of the meanings of these warnings, contact the Customer Care Department. General Safety · Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] 0 Press the START button to resume the drying process. End of the drying process The cooling phase starts shortly before the end of the drying process: The heater is switched-off during this phase. After the cooling phase the END / CREASE GUARD display is illuminated. The crease guard phase follows automatically after the drying process. If you have pressed the AUDIBLE SIGNAL button, an acoustic signal is sounded intermittently during this phase. You should remove the washing at the latest towards the end of the anti-crease phase to avoid creasing. Removing the laundry 0 Open the door and remove the laundry. 16 Drying Empty the water reservoir 1 Caution!The condensed water is not suitable for drinking or for use with foodstuffs. This avoids interruption of a programme when the water reservoir is full. 0 Grasp the handle flap of the water reservoir and pull-out completely. 0 Push the cover of the water reservoir to the side and pour-out the condensed water. If the drying cycle has not yet ended: 0 Press the START / PAUSE button to continue the drying cycle. 3 The water reservoir has a capacity of approx. This is sufficient for a laundry load of 5 kg which has been machine spun at 800 revolutions per minute. Cleaning the door seal 0 Rub the door seal with a damp cloth. 17 Drying Clean the fluff filter To ensure efficient operation of the tumble dryer, clean the fluff filter after each drying programme. Also check whether there are any remnants or fluff from the washing in the drum; remove immediately. 0 Press against the filter lid until it catches into the locking device. 3 The filter lid cannot catch shut without the fluff filter in place and the door cannot be closed. · New coloured textiles To avoid the possibility of dye transference do not dry new coloured textiles together with light-coloured laundry. 22 Cleaning and maintenance Cleaning the filter area 1 Important!When the CLEAN FILTER display lights, it is essential to clean the fluff filter. A small amount of fluff may reach the area around the filter in spite of the fluff filter. Therefore you should clean the entire filter area from time to time, or at least every three months. 0 Remove the fluff filter. 0 Hold the filter lid by the top and pull it forwards until it is released from both holders. 0 Remove the fluff from the entire filter area ­ preferably with a vacuum cleaner. 0 Press both pins of the filter lid into the holders on the door until they click in. 0 Press against the filter lid until it clicks into the lock. Cleaning the drum 1 Warning!Do not clean the stainless steel drum with abrasive deter- gents or steel wool!Fabric softeners or lime in the water can cause a scarcely visible deposit to form on the drum. The dryer is then no longer reliably able to recognise how dry the washing is. [. . . ] 3. 5kWh (5 kg Cotton, spun at 800 revolutions per minute, programme COTTONS STORAGE DRY) Area of use Household Permissible ambient temperature +5°C up to +35°C ; This appliance complies with the following EC directives: ­ 73/23/EEC of 19/2/1973 'Low voltage directive' ­ 89/336/EEC of 3/5/1989 'EMC directive' including the Modification directive 92/31/EEC 32 Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. 1 WARNING - THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is located inside the door. The appliance is supplied with a 13amp plug fitted. [. . . ]