User manual AEG-ELECTROLUX LN78470

[. . . ] ) function 95 DELAY START (STARTUITSTEL) 95 CHILD LOCK function 96 Starting the programme 96 Changing programme 96 Laundry unloading 97 CARE AND CLEANING 97 Cleaning fluff filter 97 Cleaning the door seal 99 Emptying the water reservoir 99 Cleaning heat exchanger 100 To clean the drum 101 Clean operating screen and housing 101 WHAT TO DO IF . 101 MACHINE SETTINGS 103 TECHNICAL DATA HINTS FOR TEST INSTITUTES SERVICE 104 104 105 Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] The appliance must therefore not be installed on floors which are not resistant to high temperatures. ⷠWhen operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. ⷠShould the appliance be moved, it must be transported vertically. ⷠThe appliance must not be installed behind a lockable door, a sliding door a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the tumble dryer is restricted. Details on mains voltage, type of current and the fuses required should be taken from the type plate. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Center. A B Unscrew hinge A from the front of the appliance and take off the loading door. To do this, inB A sert a thin screwdriver into the slots as shown in the illustration, push downwards slightly and pry out the cover plates. Use an appropriate tool and exert pressure to unfasten locking block C from the snapon fixture, take out and re-insert on the other side having rotated the block through 180°. Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down. if this additional function is selected , the anti-crease phase at the end of the drying cycle is lengthened by 60 minutes. to deselect function press again LONG ANTI-CREASE (ANTIKREUK LANG) button. The buzzer sounds or plays a tune when activated during: ­ cycle end ­ anti-crease phase and when phase starts or ends ­ cycle interruption by a warning ­ alarm To activate it: 1. You can select a programme duration from 10 mins to 3 hrs in 10-minute steps. With the DELAY START (STARTUITSTEL) button (7), you can delay the start of a programme by between 30 minutes (30') and a maximum of 20 hours (20h). Press the DELAY START (STARTUITSTEL) button (7) as many times as necessary until if the programme is to be the required start delay appears on the display, e. If the display is showing 20h and you press the button again, the time delay will be cancelled. The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. The child lock can be activated or deactivated by holding down the LONG ANTI-CREASE (ANTIKREUK LANG) (3) and BUZZER (ZOEMER) (4) buttons simultaneously for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed The icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. [. . . ] Use a soft detergent to clean the inner side of the drum and the drum blades. The minerals from the water or cleaning agents can collect on the inner surface of the drum. Do not use furniture cleaners or aggressive cleaning agents to clean the appliance. No drum light Abnormally elapsing time on the LCD5) Programme inactive Drying cycle to short Time to end is calculated on the basis Automatic process; this is not a maof: type, volume and dampness of launchine fault. [. . . ]