User manual AEG-ELECTROLUX L52810

[. . . ] LAVAMAT 52810 Washing machine User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Useful tips and hints Environmental information 2 Contents Operating Instructions. 43 4 Operating Instructions 1 Safety Prior to using for the first time Follow the "Instructions for installation and connection". [. . . ] If the fault is displayed again, please contact the Customer Care Department. Problem Possible cause Mains plug not plugged in or fuse not working. Check the water tap and have it repaired if necessary. END display flashes 1x. (Problems with water inflow) Filter in the screw connection of the inlet hose is blocked. Water tap is blocked with limescale or faulty. The transport lock has not Removing the transport lock. The washing machine vibrates when operating Adjust the feet as described The screw feet not correctly or is not stable. nection instructions. 22 Problem Washing has not been spun. Possible cause Only a few large items of washing in the drum. Remedy Always load the drum as full as possible. Mix large and small items. Screw connection on the inTighten inlet hose. Water is leaking out un- Drain pump cover is not derneath the washing closed properly. Clean sink outlet. Drain pump is blocked. With connection to sink outlet: sink outlet is blocked. Fabric softener not rinsed in, w compartment for additives is filled with water. Conditioner insert in the compartment for additives is not correctly attached or is blocked. Door locked. Clean detergent dispenser drawer, insert conditioner insert firmly. To remove washing: If water can be seen in the appliance, before opening the door, first drain off the water. (See section "Carrying out an emergency drain". ) Observe maximum loads. Door cannot be opened Power cut. 2 minutes. Washing is heavily creased. Possibly too much washing was loaded. 23 If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum Too little detergent is being used. Washing soiled with ointment, grease or oil was washed with too little detergent. A common cause is that fabric conditioner especially a concentrate has got onto the washing. Such stains should be washed out as quickly as possible and make sure that you are careful when using fabric conditioner. Especially with dark colours it is advisable to use liquid detergents. 24 Carrying out an emergency drain 1 Warning!Before emergency draining, switch off the washing machine and remove the mains plug from the socket. Then loosen the drain plug by turning it in an anti-clockwise direction and pull it out. If it is necessary to empty the container more than once, seal up the emergency drain hose with the drain plug while you are doing so. [. . . ] If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. There should be a minimum distance of 5. 02m (16. 5 ft) between the appliance's inlet and the bottom of the water storage tank. 38 Water drainage The maximum permitted difference between the height of the surface on which the appliance is installed and the water outlet is 1 metre. The Customer Care Department stocks outlet hoses of different lengths. Draining water into a sink outlet Secure the outlet/sink outlet joint with a hose band clip (available from your dealer). 1 Draining water into a wash basin/bath Important! [. . . ]