User manual AEG-ELECTROLUX HG 755520 UM

[. . . ] Children must get supervision to make sure that they do not play with the appliance. ⷠKeep children away from the appliance during and after the operation, until the appliance is cold. Remove all packaging, stickers and the protective layer of the stainless steel hob panel (if present) from the appliance before first use. ⷠDo not leave the appliance unattended during operation. [. . . ] ­ Speak to your local authorised facilities for disposal of your appliance. The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. It is necessary that the connection to the gas mains are carried out by means of an AGB tap. Choose fixed connections or use a flexible pipe in AGB (stainless steel) in compliance with the regulation in force. If you use flexible metallic pipes, be careful they do not come in touch with mobile parts or they are not squeezed. Make sure that the gas supply pressure of the appliance obeys the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". All the components shown in the figure have already been assembled in the factory. The appliance, before leaving the factory, has been tested in order to give you the best results. If it is possible to easily control the connection in its full area, you can use a flexible pipe. The flexible pipe is prepared for apply when: ­ it can not get hot more than room temperature, higher than 30°C; ­ it is no longer than 1500 mm; ­ it shows no throttles; ­ it is not subject to traction or torsion; ­ it does not get in touch with cutting edges or corners; ­ it can be easily examined in order to check its condition. Installation ­ it does not show cracks, cuts, marks of burnings on the two ends and on its full length; ­ the material is not hardened, but shows its correct elasticity; ­ the fastening clamps are not rusted; ­ expired term is not due. If one or more defects are visible, do not repair the pipe, but replace it. When installation is complete, make sure that the seal of each pipe fitting is correct. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in Technical Data section). Replace the rating label (it is near the gas supply pipe) with the one for the new type of gas supply. You can find this label in the package of the injectors supplied with the appliance. If the supply gas pressure is changeable or different from the necessary pressure, you must fit an applicable pressure adjuster on the gas supply pipe. If you change from natural gas 20 mbar to liquid gas, fully tighten the adjustment screw in. If you change from liquid gas to natural gas 20 mbar, undo the by-pass screw approximately 1/4 of a turn (1/2 of a turn for Triple Crown burner). Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum position. Make sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. [. . . ] These data are available on the identification plate from the injectors kit. They are available at Service Force Centre and approved spare parts shops. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. [. . . ]