User manual AEG-ELECTROLUX GA55LI102

[. . . ] Safety information Product description Control panel Use of the appliance Setting the water softener Use of dishwasher salt Use of detergent and rinse aid Multitab function Loading cutlery and dishes 23 25 26 27 28 28 29 30 30 Setting and starting a washing programme 33 Washing programmes 34 Care and cleaning 35 What to do if. Subject to change without notice Before the installation and use, read this manual carefully: · For your personal safety and the safety of your property. Always keep these instructions with the appliance also if you move or sell it. The manufacturer is not responsible if an incorrect installation and use causes damage. [. . . ] Mmol/l (millimol for each litre - international unit for the hardness of water). Press and hold function buttons B and C until the indicator lights of function buttons A, B and C start to flash. ­ The indicator light for function button A continues to flash. Each time you press function button A, the adjustment goes to the subsequent level. Fill the salt container with 1 litre of water (only with the first operation). It is correct that water comes out from the salt container when you fill it with salt. If the water softener is set electronically to the level 1, the salt indicator light stays off. Some detergent tablets do not have the best cleaning results during short washing programmes. Use long washing programmes when you use the detergent tablets to fully remove the detergent. Use of rinse aid Rinse aid makes it possible to dry the dishes without streaks and stains. the rinse aid dispenser automatically adds rinse aid during the last rinsing phase. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. To close the rinse aid dispenser, put the cap in position and turn it clockwise. You can set the rinse aid dosage between position 1 (lowest dosage) and position 4 (highest dosage). Use of detergent To help the environment, do not use more than the correct quantity of detergent. follow the detergent manufacturer recommendations on the detergent packaging. If the washing programme has a prewash phase, put a small quantity of detergent in the prewash detergent compartment 3. If you use the detergent tablets, put the tablet in the detergent dispenser 1 . Do a check if these tablets are applicable for the local water hardness. When you set the multitab function, it stays on until you deactivate it. activate the multitab function before the start of a washing programme. You cannot activate the multitab function when the programme operates. [. . . ] Put the lower spray arm in position and turn the fixing screw clockwise. To clean the external surfaces Clean the external surfaces of the appliance and control panel with a damp soft cloth. (Only To start immediately the for appliances with delay programme, cancel the start). For other fault codes, not showed in the chart, contact the service centre. [. . . ]