User manual AEG-ELECTROLUX F67032WOP

[. . . ] €¢ The water inlet hose has a safety valve and a sheath with an inner mains cable. €¢ Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge use the appliance. They must have supervision or instruction for the operation of the appliance by a person who is responsible for their safety. €¢ Keep children and pets away from the appliance door when it is open. [. . . ] Contact your local water authority to know the water hardness in your area. Manual adjustment Turn the water hardness dial to the position 1 or 2. Press and hold Delay and Start at the same time until the indicators (A), (B) and (C) flash. €¢ The display shows the setting of = the water softener. M AX + 4 3 2 - Press the release button (D) to open the lid (C). Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 1 C D You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 (highest quantity). Make sure that the appliance is in setting mode, refer to ’SETTING AND STARTING A PROGRAMME’. €¢ If the rinse aid indicator is on, fill the rinse aid dispenser. Set and start the correct programme for the type of load and the degree of soil. If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. If the control panel shows other conditions, press and hold Delay and Start at the same time until the appliance is in setting mode. Press Program again and again until the indicator of the programme that you want to set comes on. €¢ Only the indicator of the phase in operation stays on. €¢ The display shows the programme duration that decreases with steps of 1 minute. Press Delay again and again until the display shows the delay time you want to set (from 1 to 24 hours). Com • The display shows the countdown of the delay start that decreases with steps of 1 hour. €¢ When the countdown is completed, the programme starts. Make sure that there is detergent in the detergent dispenser before you start a new programme. At the end of the programme When the programme is completed, the end indicator comes on and the display shows 0. If you do not press the on/off button, the Auto Off device automatically deactivates the appliance after some minutes. [. . . ] If you connect the water drain hose to a trap spigot under the sink, remove the plastic membrane (A). A not complete removal of the membrane causes a blockage in the spigot and problems with drain. The appliance has a non-return valve that prevents dirty water to go back to the appliance. If there is a non-return valve in the sink spigot, remove it to prevent the appliance to drain incorrectly. [. . . ]