User manual AEG-ELECTROLUX F65410M0P

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. We wish you much joy with your new appliance. The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. [. . . ] With the use of the "Multi-Tab function", the cycle durations may change. In this case, in the digital display, the indication of the running time of the programme is automatically updated. Once the programme is running, the "Multi-Tab function " can NO longer be changed. If you want to exclude the "Multi-Tab function " you have to cancel the programme setting and then deactivate the "Multi-Tab function ". In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the Multi-Tab function Simultaneously press and hold the two Multi-Tab buttons (D and E), until the "Multi-Tab function" indicator light illuminates. To deactivate the function press the same buttons again until the "Multi-Tab function" indicator light turns off. Multi-Tab function 23 If the drying results are not satisfactory we suggest that you: 1. · The activation/deactivation of the rinse aid dispenser can only be possible with the "Multi-Tab function" active. Press simultaneously buttons B and C, until the lights of buttons A , B, and C start flashing. Press button B, the lights of buttons A and C turn off while the light of button B goes on flashing. The digital display indicates the current setting: = Rinse aid dispenser deactivated. To change the setting, press button B again, the digital display indicates the new setting. Open the door carefully. 26 Unloading the dishwasher Cancelling a delay start or a washing programme in progress · Simultaneously press and hold the two programme buttons positioned over the word RESET , until all the programme button lights will illuminate. · Cancelling a delay start involves also the cancelling of the washing programme set. · If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. Interrupt a washing programme in progress · Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. End of the washing programme · The dishwasher will automatically stop and an audible signal informs you of the end of the washing programme. · When the washing programme has ended, the optical signal on the floor beneath the dishwasher's door will turn off. Leave the dishwasher door ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Unloading the dishwasher · Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. · Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. Care and cleaning 27 · Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Care and cleaning Cleaning the filters The filters must be checked and cleaned from time to time. The dishwasher filter system comprises a coarse filter (A), a microfilter (B) and a flat filter. [. . . ] Please take care when installing the water inlet hose: · The electrical cable for the safety valve is in the double-walled water inlet hose. Do not immerse the water inlet hose or the safety valve in water. 37 · If water inlet hose or the safety valve is damaged, remove the mains plug immediately. · A water inlet hose with safety valve must only be replaced by a specialist or by the Service Force Centre. · Place the water inlet hose in such a way that it is never higher than the bottom edge of the safety valve. [. . . ]