User manual AEG-ELECTROLUX F60660

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. Operating instructions Safety information Correct use General safety Child safety Installation Product description Control panel The digital display Function buttons Setting mode First use Set the water softener Setting manually Setting electronically Use of dishwasher salt Use of rinse aid Adjusting the dosage of rinse aid Daily use 3 3 3 3 3 4 5 6 7 7 7 8 8 8 9 9 10 11 11 Washing programmes Select and start a washing programme Unloading the dishwasher Care and cleaning Cleaning the filters Cleaning the spray arms External cleaning Internal cleaning Prolonged periods of non-operation Frost precautions Moving the machine What to do if. [. . . ] Press button B, the lights of buttons A and C turn off while the light of button B goes on flashing. To change the setting, press button B again, the digital display indicates the new setting. If you decide to turn back to the use of standard detergent system we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Mixed nor- Crockery, mal and cutlery, heavy soil pots and pans Heavy soil Crockery, cutlery, pots and pans Crockery and cutlery Crockery and cutlery Delicate crockery and glassware Partial load (to be completed later in the day)6) Crockery and cutlery 1) The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply and the amount of dishes. The programme duration, water and energy consumption levels can vary; this depends upon if the appliance is fully or partially loaded and if the dishes are lightly or heavily soiled. This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. 6) This programme does not require the use of detergent When a programme is selected the corresponding programme light illuminates and the programme time flashes on the digital display. If you want to set the NIGHT CYCLE programme, press the NIGHT CYCLE button, the corresponding indicator light comes on. After having selected the washing programme, press the delay start button until the number of hours for the delay start appear in the digital display. The start of the selected washing programme can be delayed for between 1 and 19 hours. Close the door; the countdown will continue from the point at which it was interrupted. The selection of the washing programme and delay start can also occur with the door closed. Keep in mind that in this way, once a washing programme button is pressed you have ONLY 3 seconds in which you can choose another programme or select a delay start, after which the selected programme will start automatically. Press the RESET button until all the programme lights will illuminate. ⷠIf a new washing programme is to be selected, check that there is detergent in the detergent dispenser. Close the door; the programme will start from the point at which it was interrupted. Press the On/Off button again; the programme will start from the point at which it was interrupted. It is recommended to switch off the appliance once the washing programme has ended. If this is not done, automatically after about 3 minutes from the end of the programme, all indicator lights will go off. This will help to reduce the consumption of energy when you forget or for any reason cannot switch the appliance off once the programme has ended. [. . . ] Please take care when installing the water inlet hose: · the electrical cable for the safety valve is in the double-walled water inlet hose. A water inlet hose with safety valve must only be replaced by a specialist or by the Service Force Centre. to the sink outlet spigot , securing it to the underside of the work surface. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. [. . . ]