User manual AEG-ELECTROLUX EWT 9125 ERRATA

[. . . ] If all transit packaging is not completely removed, the appliance or surrounding furniture could be damaged. ⷠConnection to the water supply must be carried out by a qualified plumber. ⷠIf your domestic electrical circuit needs adapting to allow the appliance to be plugged in, use a qualified electrician. ⷠEnsure that, after installation, the power cable is not trapped under the appliance. [. . . ] Selection of desired programme You can find the right programme for different types of washing in the programme table (see "Programme table"). The symbols which correspond to the different stages of the cycle are displayed ( Wash, Rinse, Drain, Spin). Before closing the lid of your appliance, ensure that the drum is properly closed : · When the two shutters are closed, · If you turn the programme selector to another programme while a cycle is in 10 how to run a wash cycle "Err" flashes and the "Start/Pause" pushbutton flashes red for a few seconds then the current cycle display reappears. Selecting the temperature Press the "Temperature" pushbutton repeatedly to increase or decrease the temperature if you want your washing to be washed at a different temperature to the one selected by the appliance. Selecting the spin speed Press the "Spin" pushbutton to change the spin speed, if you want your washing to be spun at a different speed to the one selected by the appliance. At the end of the programme, if you have selected "Rinse and hold" or "Night silence plus" , you then need to select *depending on model "Night silence plus" The washing machine does not empty the water after the final rinse which prevents the washing from creasing. Because there are no spin cycles, the washing programme is very quiet and can be selected at night. in Cotton and Synthetics programmes , the rinsing cycle uses more water. Selecting options You must select the different options after selecting the programme and before pressing the "Start/Pause" pushbutton (see "Programme table"). If one of the options is not compatible with the selected programme, "Err" flashes on the display and the "Start/ Pause" pushbutton flashes red. The prewash finishes with a short spin cycle for cotton or synthetic programmes, and with an empty cycle for delicates programmes. If a delayed start has been selected, the countdown appears on the display (hour by hour, then 90, and minute by minute from 60 min). During the cycle, the symbol comes on when the appliance is reaching the right temperature. How to run a wash cycle 13 We recommend leaving the lid and drum open after use to ventilate the water tank. If the appliance is on but no commands are selected for 10 min before or after a cycle, it goes into standby mode. To exit standby mode, simply press any pushbutton or turn the programme selector. Sort washing by type and care label (refer to International symbols section below) : normal wash for tough fabrics which can withstand intense washing and spinning cycles ; delicate wash for delicate fabrics which need to be treated with care. For mixed loads, loads with items of different types of material, choose a programme and a temperature suitable for the most fragile material. ⷠWash whites and colours separately : Otherwise, whites will be coloured or will turn grey. Follow care instructions "wash separately" and "wash separately several times". ), coloured headwear, wool and material with printed designs inside out. Wash loads depending on type of materials The amount of washing placed in the drum must not exceed the maximum capacity of the washing machine. [. . . ] Ensure the appliance does not come into contact with the wall or other furniture. To move the appliance, proceed as follows : To move your ap1 pliance, place it on its rollers by pulling the lever located at the base of the appliance hard from right to left. Once the appliance is in the desired position, push the lever back to its original position. Accurate levelling avoids vibrations, noise and prevents the appliance from moving when running. [. . . ]