User manual AEG-ELECTROLUX EWT1066EDW

[. . . ] If all transit packaging is not completely removed, the appliance or surrounding furniture could be damaged. â· Connection to the water supply must be carried out by a qualified plumber. â· If your domestic electrical circuit needs adapting to allow the appliance to be plugged in, use a qualified electrician. â· Ensure that, after installation, the power cable is not trapped under the appliance. [. . . ] "Err" flashes and the "Start/Pause" pushbutton flashes red for a few seconds then the current cycle display reappears. 10 how to run a wash cycle At the end of the programme, if you have selected "Rinse hold" or "Night silence plus", you then need to select a "Spin" or "Drain" programme to finish the cycle. Press the "Temperature" pushbutton repeatedly to increase or decrease the temperature if you want your washing to be washed at a different temperature to the one selected by the appliance. "Night silence plus" The washing machine does not empty the water after the final rinse which prevents the washing from creasing. Because there are no spin cycles, the washing programme is very quiet and can be selected at night. in Cotton and Synthetics programmes , the rinsing cycle uses more water. "Rinse hold" The washing machine will not drain the water from the last rinse, so will not crease the laundry. Selecting options You must select the different options after selecting the programme and before pressing the "Start/Pause" pushbutton (see "Programme table"). If one of the options is not compatible with the selected programme, "Err" flashes on the display and the "Start/Pause" pushbutton flashes red. Press the "Spin" pushbutton to change the spin speed, if you want your washing to be spun at a different speed to the one selected by the appliance. How to run a wash cycle 11 Hold down the "Prewash" and "Delay start" pushbuttons for a few seconds. Cancelling the programme If you want to cancel the programme, turn the programme selector to the "Stop" position. End of the programme The washing machine stops automatically ; the "Start/Pause" pushbutton goes out and "0" flashes on the display. The lid can only be opened around 2 minutes after the washing machine has come to a stop. If the appliance is on but no commands are selected for 10 min before or after a cycle, it goes into standby mode. To exit standby mode, simply press any pushbutton or turn the programme selector. We recommend leaving the lid and drum open after use to ventilate the water tank. Sort washing by type and care label (refer to International symbols section below) : normal wash for tough fabrics which can withstand intense washing and spinning cycles ; delicate wash for delicate fabrics which need to be treated with care. For mixed loads, loads with items of different types of material, choose a programme and a temperature suitable for the most fragile material. â· Wash whites and colours separately : Otherwise, whites will be coloured or will turn grey. Follow care instructions "wash separately" and "wash separately several times". ), coloured headwear, wool and material with printed designs inside out. [. . . ] Ensure the appliance does not come into contact with the wall or other furniture. To move the appliance, proceed as follows : To move your ap1 pliance, place it on its rollers by pulling the lever located at the base of the appliance hard from right to left. Once the appliance is in the desired position, push the lever back to its original position. Accurate levelling avoids vibrations, noise and prevents the appliance from moving when running. [. . . ]