User manual AEG-ELECTROLUX EWB105405W

[. . . ] ⷠIf the appliance is installed on carpeted floor, ensure that the carpet does not obstruct any ventilation ducts located at the base of the appliance. ⷠThe appliance must be equipped with an earthed power plug which conforms to regulations. ⷠBefore connecting your appliance to the power supply, carefully read the instructions in the chapter entitled "Electrical connection". ⷠReplacing the power cable should only be carried out by an authorised service engineer. [. . . ] "Prewash" option The appliance runs a prewash at 30°C max. "Extra rinse" option The washing machine will add one or more rinses during the cycle. This option is recommended for people with sensitive skin and in soft water areas. Permanent : Hold down the "Prewash" and "Delay Start" pushbuttons for a few seconds. "Delay start" This option allows you to delay the start of a wash programme by 30, 60, 90, 2 hours to 20 hours. You can change or cancel the delayed start time at any time before you press the pushbutton, by pressing "Start/Pause" the "Delay start" pushbutton again (0' indicates immediate start). If you have already pressed the "Start/ pushbutton and you want to Pause" change or cancel the delayed start, proceed as follows : To cancel the delayed start and start the cycle immediately, press "Start/Pause" and then "Delay start" . To change the timer delay period, you position must go through the "Stop" and reprogramme your cycle. If you need to open it, you must first pause the appliance by pressing the pushbutton. After closing "Start/Pause" the lid again, press the "Start/Pause" pushbutton. Using the "Time Manager" The level of soiling of the laundry is also indicated. Warming up During the cycle, the symbol comes on when the appliance is reaching the right temperature. Interrupting a programme Adding washing is on, you When the "Add washing" light can add washing by proceeding as follows. Pushbutton : Press the "Start/Pause" the corresponding light will flash green while the appliance is paused. The lid can only be opened around 2 minutes after the washing machine has come to a stop. press the pushbutton again to con"Start/Pause" tinue the programme. Modifying the programme in progress Before making any changes to the current programme, you need to pause the washing machine by pressing the "Start/Pause" pushbutton. If the modification is not possible, "Err" flashes in the display and the pushbutton flashes red for "Start/Pause" a few seconds. [. . . ] The temperature inside the drum is too high, · The wash cycle is much too long : The washing machine stops during a wash cycle : The lid doesn't open at the end of the cycle : The error code appears in the display1) and the "Start/Pause" button flashes red 2) : 10 electrolux Problems The error code appears in the display1)and the "Start/ Pause" button flashes red2): The error code appears in the display1) and the "Start/Pause" button flashes red2): The error code appears in the display1) and the "Start/Pause" button flashes red2): The drainage pump runs constantly, even when the appliance is inactive : Softener runs directly into the drum when filling the dispenser box: · The anti-flooding security system has been activated, please proceed as follows : - close the water inlet tap, - empty the appliance for 2 minutes before unplugging, - call the after-sales service. ⷠThe anti-flooding security system has been activated, please proceed as follows : - close the water inlet tap, - empty the appliance for 2 minutes before unplugging, - call the after-sales service. 1) On some models, the audible signals can sound 2) After solving any problems, press "Start/Pause" button to restart the interrupted programme. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. [. . . ]