User manual AEG-ELECTROLUX ESL65070R

[. . . ] Thinking of you. Share more of our thinking at www. electrolux. com CONTENTS Safety information Product description Control panel Use of the appliance Setting the water softener Use of dishwasher salt Use of detergent and rinse aid Multitab function 2 4 5 6 7 8 8 9 Loading cutlery and dishes 9 Setting and starting a washing programme 10 Washing programmes 10 Care and cleaning 11 What to do if. . . 12 Technical data 14 Environment concerns 15 Subject to change without notice SAFETY INFORMATION Before the installation and use, read this manual carefully: · For your safety and the safety of your property. Always keep these instructions with the appliance also if you move or give it to a different person. The manufacturer is not responsible if an incorrect installation and use causes damage. [. . . ] Setting mode The appliance must be in setting mode for these operations: · To set and start a washing programme. · To activate or deactivate the rinse aid dispenser (only with the multitab function on). The appliance is in setting mode when: · All the programme indicators are on. The appliance is not in setting mode when: · Only one programme indicator is on. · The delay start indicator is on. ­ It is necessary to cancel the programme or the delay start to go back to the setting mode. Acoustic signals You can hear the acoustic signals in these conditions: · The washing programme is completed. Press and hold function button (B) and function button (C) at the same time until the indicators of function buttons (A), (B) and (C) flash. Press function button (C), · The indicators of function buttons (A) and (B) go off. Press function button (C), the end indicator comes on and the acoustic signals are active. USE OF THE APPLIANCE 1. Be sure that the set level of the water softener agrees with the water hardness in your area. If you use the combi detergent tablets ('3 in 1', '4 in 1', '5 in 1'), use the multitab function (refer to 'Multitab function'). electrolux 7 SETTING THE WATER SOFTENER The water softener removes minerals and salts from the water supply. These minerals and salts can cause damage to the appliance. Water hardness German degrees (°dH) 51 - 70 43 - 50 37 - 42 29 - 36 23 - 28 19 - 22 15 - 18 11 - 14 4 - 10 <4 1) Factory position. It is correct that water comes out from the salt container when you fill it with salt. USE OF DETERGENT AND RINSE AID 1 2 3 4 5 4. If you use detergent tablets, put the tablet in the detergent dispenser 1 . Detergent tablets do not fully dissolve with short washing programmes and can decrease the washing results. Use of rinse aid Rinse aid makes it possible to dry the dishes without streaks and stains. Rinse aid is automatically added during the last rinsing phase. 30 20 + M AX 4 32 - 1 8 7 6 Use of detergent To help the environment, do not use more than the correct quantity of detergent. If the washing programme has a prewash phase, put a small quantity of detergent on the inner side of the appliance door. To fill the rinse aid dispenser: 1. Remove the spilled rinse aid with an absorbent cloth to prevent foam during the washing programme. Adjust the rinse aid dosage Factory set: position 3. electrolux 9 You can set the rinse aid dosage between position 1 (lowest dosage) and position 4 (highest dosage). Turn the rinse aid selector 4 to increase or decrease the dosage. MULTITAB FUNCTION The multitab function is for combi detergent tablets. These tablets contain agents as detergent, rinse aid and dishwasher salt. Be sure that these tablets are applicable for the water hardness in your area (refer to the instructions on the packaging of the products). [. . . ] Make sure that it assembles correctly in the two guides (C). C WHAT TO DO IF. . . The start of the appliance does not occur or it stops during operation. If not, contact the service centre. Alarm code · The programme indicator flashes continuously. · The end indicator flashes three times intermittently. With some malfunctions the indicators flash to show an alarm code. Malfunction The appliance does not fill with water. Deactivate the appliance before you do the checks. Malfunction The appliance does not fill with water. [. . . ]